answersLogoWhite

0


Best Answer

Take the two screws out holding the clear lens of the backup light. Take the lens and gasket out.

Turn the bulb counterclockwise about a 1/4 turn and pull it out.

If the bulb won't budge, you can try this: Unhook battery. Maybe use some WD-40 or other penetrating spray.

Get some needlenose pliers and break the bulb, then use the pliers to turn and pull it out.

Clean up the broken pieces and make sure to dry the area before putting the new one in.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change the back up light bulb on a 1966 mustang?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the difference between a 1965 mustang and a 1966 mustang?

One of the most notable change for 1966 Mustang was the revised grille the revered running horse centerpiece also became fully floating in 1966. Additional brightwork adjustments included making hood lip trim and rocker moldings standard for the base model. Completing the extior makeover were typically redesigned wheel covers,a restyled gas cap in back,and new standard backup lights


Where is the exhaust air check valve located on a 1966 Mustang?

That's a new one by me. They did not do anything with the exhaust besides exit it out the back of the car.


Where is the back-up lamp switch in a 1966 ford mustang with 4-speed manual transmission?

The back-up switch is located on the transamission near the back, it is activated by the shifter rod when going into reverse. :: AverageJoeResto.com ::


How do you change the switch for a convertible top in an 87 mustang?

u take off the speedodomater cover unplug the top and the fog light switch and it pops right out put a new one in and put it back together


Where is the starte netural switch for your back up lights on your 1966 ford mustang?

The back up light switch is mounted directly to the transmission. When you engage the shifter into reverse, the shifter physically actuates the switch's button, turning the back up lights on. It's a simple, but effective little system.Note: If you're doing a T5 swap or a similar project, the original back up light switch bracket will not adapt to the new transmission. You will need to have one custom fabricated.


How do you reset check engine light on 1995 mustang?

With a scan tool or by unhooking the battery. If the cause is not repaired, the light will come back on. See related questions for more info.


How do you remove tail light dodge charger 1966?

remove the bolts from inside the trunk in back of the taillights.


How do you change the headlight bulb on a 2002 Ford Mustang?

Pull out the light by pulling out the two metal rods holding your headlight in place. Take the headlight out by slightly turning the plastic rings around the back of your light. It should loosen up. When it does, just mess with it a little to pull it out, pull out the bulb and replace! =)


What direction does water flow through a 1966 mustang radiator?

Once the thermostat has opened, the hot coolant flows from the thermostat housing on the engine into the top of radiator and out the bottom of the radiator back into the water pump.


How do you change a 1990 mustang headlight assembly?

Begin by removing the wiring harness from the back of your 1990 Ford Mustang headlight assembly. Remove the headlight assembly retaining bolts. Reverse the process to install your new headlight assembly.


How do you change the brake light in a 1992 Lincoln Continental?

remove the trunk lining or bend it back easy where the brake light is to access it and change it out.


What is a Krieger Mustang horse?

a Krieger Mustang horse is a breed traced back to the Spanish conquistadors.