if you have ignition coils you have to remove them and the intake tube (3000) then you can take the spark plugs out
Remove the 4 allenhead bolts from the v-6 3000 emblem in center of the valve cover. Lift off { Tshapped v-6} 3000 emblem. Remove spark coils located beneath. Remove plugs under spark coils. As far as I know you must replace coils and wires together. However you can replace just the plugs.
how to change an alternator Mitsubishi shogun 3000 v6
Refer to your service and user manual on how to change an alternator ground wire on a 1994 Mitsubishi 3000 GT.
Change oil every 3000 miles. At 100,000, change the timing belt, water pump, coolant, and spark plugs. Replace the air filter as needed.
damaged thread in head or spark plug. not tightened right or damaged plug
Lay out new ones by length start with shortest and replace one by one routing the same way. They basically snap on to plugs/coil in most cases
Spark plugs screw into the engine heads. They can be removed with a deep well socket of the proper size and a ratchet. The leads, or plug wires, simply slid on to connect. remove plug wires one at a time, and pick the closest length wire from the new wiring kit to replace it, as the kit will have wires of several lengths much like the original wires.
Try changing spark plugs and wires
if you are not getting spark in your coils iti could be the crankshaft sensor im not a mechanic lol but i have the same problem with mine im trying to find out how to install the sensor i replaced the coils and the ignition module and still no spark
If you have no spark check with the electrical basics first- battery and alternator.
in the trunk