How do you change rear bearings Toyota Rav4?

Answer 1

1. Jack up Vehicle
2. Support with Jack Stands
3. Remove Road Wheel
4. Remove Bake Components from Backing Plate
5. Remove Hand Brake Cable from Backing Plate
6. Remove and plug Brake Pike from Backing Plate
7. Remove Axle Circlip
8. Remove Lock Plate
9. Remove Axle Nut
10. Remove four Backing Plate Nuts
11. Remove Wheel Locateing Unit, Bearing Unit and Backing Plate from Axle as one unit.
12. Take above to an Engineering Shop and get them to Split the Wheel Locating Unit and Bearing Hub from Each other.
13. Clean and inspect all components
14. Get the Engineering Shop to press the New Bearing Unit and Wheel Locating Plate together. Remember to position the Backing Plate before pressing.
15. Reasemble in the reverse order.
16. Locate the Hand Brake Cable onto the Backing Plate.
17. Locate the Brake pipe onto the Backing Plate.
18. Bleed the Brakes
19. Check and adjust the Brakes
20. Check and adjust the Hand brake
21. Torque the Axle Nut
22. Insert the Locking Plate
23. Insert a New Split Pin
24. Replace Brake Drum
25. Insert the Road Wheel
26. Check for binding and correct operation
27. Lower the vehicle
28. Road Test