Remove 2 screws holding lens/cover over lamps.
The bulb should pull straight out as they are the "wedge" type.
Note that if the bulbs will not pull out easily they are probably melted into the sockets. I just had this happen. The lamp bases were melted and required replacement. I believe Kia may have a recall on this since the lamp connector cannot handle the heat and this IS a manufacturing/design defect.
Change brake light bulbs Just remove the rear license plate. You can change the backup lights and brake light easily.
you need to remove the inside panel to get to these bulbs
They are located inside the trunk lid, underneath the felt lining. You need to unsnap and pull back the felt lining to access the bulbs for the license plate light.
from inside the trunk pop all of the plastic rivots and you can access the bulbs from the inside..
They are located inside the trunk lid, underneath the felt lining. You need to unsnap and pull back the felt lining to access the bulbs for the license plate light.
bend over sheave it up ur asss
Who to Change engine check light bulbs on a 1996 BMW 318i?
The clear covers for the license plate light bulbs have small arrows pointing in one direction. Simply push the cover to the direction of the arrows and the covers will slide off allowing for the old light bulbs to be replaced.
Not enough info - WHAT bulbs?
HOW DO I CHANGE LIGHT BULBS
= Answer = you dont
What is the part number for the 2008 HHR tail light bulbs and backup light bulbs?