0
I just did this today on my 1996 Tacoma 2WD, don't know if it's the same for 1999 though. Four Philips-head screws hold the taillight assembly to the body. Remove them obviously. Separate the lense from the taillight assembly body, there will be a rubber seal between them, I removed the seal from sticking to the two parts but you may get away with leaving it stuck to one part or the other. Now you have access to the various bulbs inside (tail/brake, backup, and turn signal). I replaced the tail/brake bulbs with LED replacements (FYI). Reverse the process to reassemble, if you removed the seal from both parts, putting it back on the taillight assembly bosy side seemed easier than on the lense. One thing to be careful of, at least on mine, each of the four screws on each side had small nearly-clear washers on them, upon reassembly I could not find one of the washers, not sure if it was there when I disassembled it or not. So be careful removing the screws, keep an eye on the washers, so they don't disappear like one of mine may have.
Add your answer:
Earn +20 pts
Do 2001 tacoma tail lights fit 1999 tacoma?
Yes, they should fit.
What color is the positive and negative wire for 2005 Toyota Tacoma tail light?
The positive wire for the 2005 Toyota Tacoma tail light is red with white stripes. The negative wire is white with black stripes.
Toyota Tacoma troubleshooting 1996 Toyota Tacoma brake lights not working cab brake light works Tail light bulbs ok?
Yes
What type of taillight bulb does a 1999 Tacoma need and how do you replace it?
Go to the WWW address below. The tail light is mounted with 4 screws. http://www.sylvania.com/ConsumerProducts/AutomotiveLighting/LampReplacementGuide/
Toyota Tacoma 2005 blows tail light 10amp fuse when you hit the brake pedal?
Short in the wiring or one of the tail light sockets is corroded or shorted out.
How do you change a tail light on a 2006 sequoia?
how to change tail light bulb on Toyota sequoia
How do you change tail light in Toyota sequoia?
How do you change the tail light on a 2001 toyota sequoia
How do you get to the rear brake light bulbs on a 1999 Nissan Frontier?
You have to unbolt the entire tail lamp assembly to change the bulbs. Unbolt the tail lamps from inside the corners of the bed, replace the light bulbs, bolt the tail lamps back in place.
How do you get to the rear tail light to change it on a 94' crown Victoria?
on the tail light problem - unbolt the tail light from inside th truck -the hold tail light assemble will come out - it is recommended to change all the blubs your all ready there
How do you remove 2010 tacoma tail light?
to remove tail light's. open the tail gate. remove the 2 10mm bolts with out washers on each side..then you must pull the light straight back....it will be tight but their are no more bolts holding it, only plastic tabs..
How do you change the tail light bulb on a 1999 beetle?
Take the rear light screws out of the corners of the crome backing. For bulb information see related link below.
How do a change a tail light in a 1999 Olds Alero?
In trunk remove thumb screw, bend back paneling, remove 3 thumb screws and pull out whole tail light fixture. Now you can replace bulb(s).
