answersLogoWhite

0


Best Answer

You don't. There is not a clutch cable on a 1998 integra. It has a hydraulic clutch.

User Avatar

Wiki User

βˆ™ 16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change a clutch cable on a 1998 integra?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can a 1998 Acura Integra automatic transmission fit in a 1991 Acura Integra?

it will fit but you need to convert it to a cable clutch because the 98's are hydraulic


Does 1998 Honda Prelude have a clutch cable?

Does a 1998 Honda prelude have a clutch cable


Why is the clutch on your 1998 subaru legacy outback stuck to the floor?

Your clutch cable snapped. It should be an easy fix.


Does a 1998 ford escort have a clutch cable?

I'm not a mechanic / technician but I would say ( no ) It is a hydraulic clutch on a 1998 Ford Escort The BRAKE FLUID RESERVOIR is also the CLUTCH FLUID RESERVOIR


How do you replace a clutch cable on a 1998 Seat Inca diesel 1900 van?

Can adjust a self adjusting cable


How do you change the clutch on Renault megane 1.4 1998?

Disconnect the negative cable from the battery. Disconnect the clutch mechanism. Place the car on a jack and remove the engine mounts. Remove the clutch disk along with the other parts. Replace it with a new one.


Is your clutch hydraulic or cable its a 1998 fiesta 1.8 diesel?

Run car at idle and press / depress clutch. If RPMsfluctuate it's hydraulic.


How do you adjust a 1998 Nissan 200sx clutch?

I have replaced the the clutch cable on my '95 200sx 1.6L and it was easy. To adjust the cable go to the end of the cable where it conects to the level looking clutch arm in the engine compartment and look at where the clutch cable connects to the lever. Securing the cable on the backside of the lever there is a washer and screw that you can tighten or loosen to engage the clutch without pushing it all the way to the floor or you can adjust the other way to get the opposite affect. After I installed my clutch cable I had to go back about a week later and adjust the clutch (tighten the cable) because it appeared the cable had stretch a little from brand new to broken in condition. Hope this helps...


When was Integra Air created?

Integra Air was created in 1998.


How do you change a master cylinder for a 1998 Chevy S10?

How do you change a Master Cylinder and hydraulic clutch line for a 1998 Chevy S10?


Would a 1998-01 Acura Integra front bumper fit on a 1997 Acura Integra?

Yes you just need to change the headlights and bumper lights along with the bumper


How do you change clutch cable on 1998 Nissan 200sx How do improve engine acceleration on 1998 Nissan 200sx 1.6L?

the cluth cable is attached to the very top and back side of the clutch pedal by a small hook. Simply slide the hook end of the new cable to it. the other end goes through the firewall located by the stering colume. Attach the other end of the cable w/ the adjustible threaded side to the release lever located on the transmission housing top side. Tighten down the cable w/ a 10mm wrench until the cable is tight anbd your done