In a 2004 Mitsubishi Lancer replacing the rear light bulb is relatively easy. First remove the plastic cover from the dome light. Unscrew the light bulb and insert the replacement.
I just had the same problem with my 02 Lancer. I found a bad fuse 10 amps, enclosed in a yellow plastic holder, cap, ...There are 2 10 amp fuse in this holder. The fuse is located under the hood, driver side fuse box. Hope this helps...Good luck
The Montero Sport's tailgate dome light doubles as the switch. The entire clear plastic cover slides left to right and has three positions. ON-DOOR-OFF
To replace the dome light in your 2005 Toyota, you will need a flat screwdriver to remove the screws and pry the dome light cover from the light. You can then access the light to change the bulb or replace the entire bulb and cover.
looked at the fuse panel in the car and under the hood and it doesn't even say where the fuse for the dome light is. How stupid is this?
take a screw driver, there should be a small rectangular indent in the of the dome light. gently, with a screw driver (standard screw driver) pry it off. theres two bolts on each side near the outer bulbs. now take a 10mm socket wrench and take out the two bulbs, in doing so you remove the entire assembly. gently pull out the light bulbs, which consists of the bulb and contacts, the bulbs themselves wont come out on their own. there you have it
light bulb out on map light how to change with out breaking plastic lens
Just fixed mine today. The dom light fuse in the engine fuse compartment was blown. The radio/power locks will go out as well if this fuse blows.
If dome lights and sunroof of a Mitsubishi Galant are not working, it is probably due to blown fuse. It is time to replace old ones.
The dome light fuse on a 2003 Jeep Liberty can be changed by first locating the fuse panel near the hood release. The dome light fuse can then be pulled from its socket and a new fuse put in place.
how do i change front interior light for lexus rx 300 2004 model
Take the cover off the dome light with a flat head screwdriver. Insert the screwdriver carefully into the small indet in the back of the dome light. pry carefully and the cover will pop off. Pull the bulb out and snapo the new one in. For side bulbs you will need to use a Phillips screwdriver and remover the dome light from the ceiling after the cover is removed.