Miata Frankenstein Bolts are hardtop posts available to all Miatas from 1990-2005. They are equipped on Miatas that have removable hardtops. The Frankenstein bolts are mounted on the small chrome pieces near the upper corners of the trunk. The rear of the hardtop has two chrome covers that include bolts and shims that will tighten around the frankentstein bolts to secure the rear of the hardtop to the car. If your Miata does not have them, they can purchased to replaced the two chrome bolts closest to the rear window on the chrome piece. While installing them with a Phillips head screwdriver, Loctite is recommended to ensure the bolts do not back out. While not safe to do so, I have installed a hardtop without the Frankenstein bolts to see what would happen. Running only the front latches attached, I was able to drive around with minimal risk up to 60mph. Above 60mph, the generated air began lifting the rear of the hardtop in the air, creating a 1-2inch gap between the hardtop and the car. Do so at your own risk, but if you want to purchase a hardtop, do not have the means to carry it by truck and do not have Frankenstein bolts, it is relatively safe to mount it to your Miata for transport at low speeds.
4x4
The 1992 Mazda Miata is equipped with a non-adjustable steering wheel.
Stick your hand out and adjust the mirror inside the housing.
In the books by Mary Shelley, the Creature did not have bolts in his neck. In popular interpretation, however, he is depicted with bolts.
The bolts
No. The Miata 1.6 uses hydraulic lifters so there are no adjustments. If you are experiencing valve train chatter you have to replace the lifters.
Hold the 'clock' button until it starts to blink, adjust the time and poke the 'clock' button to accept the time.
The popular image of Frankenstein's monster is a large green man with bolts in his neck. Shelley describes him as having transparent yellow skin and patches of hair, rather than a full head. Remove the bolts, and Hollywood's image is pretty close.
remove the panels in the boot across the back and you will se them behind there
The EGR Valve is located behind the intake manifold, and held by two bolts.
A Pearson Renegade compound bow may be adjusted by tightening the limb bolts. These bolts will help adjust the weight of the bow. The bolts are hexagonal and need to be rotated in the same manner - the top and bottom. The best way to adjust the bow is to take it to a shop that specializes in archery so they can properly adjust the weight.