jack up vehicle and put on stands as u need to get under it!
remove wheel undo the big nut in the centre of hub assembly (middle of disk brake) then u need to undo the 2 bottom shock bolts that hold that hub assembly to the shock but u need to mark the position of the top bolt head as this is your cars camber adjustment.
once the bolts are out u can pull the end of the shaft out of the hub
then u need to slide under the car with a pin punch and hammer and tap the pin out of the inner shaft joint then u can pull shaft off the splines and out of the car...
when putting shaft back in u need to align shaft and splines on gearbox output properly to allow pin to go back in if it wont align properly u need to pull it off and spin the shaft 180 degrees and slide it back on
why is subaru forester 1998 hold light flashing
Inside the fuel tank
The odometer on a 1998 Forester, just as any other modern car, has a million-mile speedometer.
Yes, it is the handle on the outside of the hatch.
That means that the car is in low gear.
What is manfacture tire pressure for a1998 forrester
Knock sensor/vibration sensor
Not necessarily.
where is the pvc valve on a 1998 suaru forester?
ECU is on the passenger's side front floorboard. There are a couple of retaining clips that hold the carpet in place. Remove those and pull the carpet back.
Go to your local auto parts store and get the Haynes manual (or similar) for your Forester. Cost about $20. Read and see if you feel that your skills are up to doing the procedure. Otherwise, leave this to a professional. --Ken
The 1998 Subaru 2.0 liter turbo engine has a rated horsepower of 180. The horsepower can be increased by adjusting the fuel pump.