0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where can i find a diagram for vacuum lines on a 1992 Isuzu rodeo?
You can find the diagram for a 1992 Isuzu rodeo at the Isuzu website. There are options available to purchase a factory-direct Do-It-Yourself kit, with the diagram.
What grade is the fluid for the differentials of a 1992 Isuzu Rodeo?
90 grade
Does a 1992 Isuzu Rodeo 3.1 V6 have a timing belt or chain?
Chain.
Where is the automatic shut-off switch located on a 1992 Isuzu Rodeo 2WD?
There is none.
Can you replace a rear axle from a disc brake 1992 Isuzu Rodeo to a 1992 Isuzu Rodeo with drum brakes just the axle?
I don't think that will work unless you change over to rear disc brakes, the hub should not match.
Where is the automatic fuel switch shut off located on a 1992 Isuzu Rodeo?
In recent experience, I have learned that a 1992 rodeo does not have a cut off switch and that on most the fuel pump is in the tank!
Why won't my 1992 Isuzu rodeo change gears automatically?
probably a stretched out tv/kickdown cable
How do you change the fluid in a manual transmission in 1992 rodeo v6?
Trannythese Isuzu transmissions take dextron III with mercron
Where is the starter on a 1992 Isuzu rodeo 4 cylinder engine?
Starter is on passenger side of motor underneath intake bolted to trans bellhousing.
Where is the 1992 Isuzu Rodeo fuse box location?
It's right next to the hood release on the left hand side. It says 'Fuse' on it.
How do you reset the computer when the 'check engine' light comes on in a 1992 Isuzu Rodeo?
well u have 2 blah blah,.mml;jhnj
How do you install an alternator on 1992 Ford E350?
Start by disconnecting the negative battery cable, then loosen the hinge and bracket bolts on the alternator. There should only be one of each. Rotate the alternator around the bracket to release tension on the belt and electrical wires far enough that they can be disconnected. Remove the bracket bolt then the hinge bolt and the alternator should come right out. Installation is the reverse of removal. To tighten the belt back up, be sure the bracket bolt is loose then use a prybar between the alternator body and the engine block to pry the alternator along bracket. When the desired tension is reached, tighten the bracket bolt back down. Boom Done
