there is a clip on the front of the shifter. pull this out and the outer part of the shifter will come off. next remove the center console. then you can get to the 4 bolts that hold the shifter in place.
The shifter knob has a slot in the leather about halfway down. In that slot is a u shaped clip. pull it out and lift the knob as an assembly.
bash it with a hammer.
Please visit my bio for access to my Saturn help site. here you will find a diagram of the factory wireing to assist you in installing your aftermarket radio.
Remove any screw you find and then pull on it. its mainly held in by plastic thingys
On a manual transmission the bushing is located below the top cover of the transmission. remove the shifter boot and unbolt the 3-4 bolts that hold the shifter down.only available from your local dealer.
Remove u-joint clip (CV Joint), remove as an assembly, press bearing out.
Remove boot There should be 4 bolts that hold the shifter into the transmission Make sure transmission is in neutral when removing
I don't know - but the question about the 1993 door handle is the same...
If it is just the shift knob you want it will turn off ( there may be a jam nut at the bottom to loosen first ) As for the entire shifter, remove the shift knobs, boots, carpet, and the two metal panels at the floor, then remove the 2 bolts and 2 nuts at the top of the shifter housing, then remove the bolts on the side and back of the 4wd shifter bracket located on the drivers side of the trans, once that is done you can kinda move it out of the way without removing the linkage. Now you have access to the 2 bolts on the drivers side of the housing, remove those and the shifter assembly will pop right out.
Shifter cables are held in by clips at the tranny. Remove the U clips and unhook them from the tranny. Inside the cabin, remove the center console. Using a screw driver remove the bushings from the shifter. A little force may be needed for this. Then remove the 2 bolts holding a metal plate around the cables. With a long screw driver try to push the rubber insert in the fire wall towards the engine bay from inside the car. Once removed from the firewall, pass once cable through at a time. Again a little force is needed, as the hole is very tight.
Sailor Saturn was created in 1994.