The thermostat in the 2002 b2300 Mazda pickup truck is located on the engine block, facing the drivers side of the vehicle, towards the front of the engine and in back of the the radiator. It has hoses that come out of it and sensor wires.
There are three bolts that hold it in. After removing the 2 radiator hoses, the sensor terminal/receptacle, and screws, the whole unit comes out as one piece.
My particular thermostat went bad and stuck in the closed posistion. This resulted in my temp gage/enging never reacing full operating temperature.
how du you replace a thermostat in Mazda pickup b2300 94
how do you change the thermostat on a 2002 ford zx2
take the gas cap off
Where is the thermostat located on a mazda 626 2002
To change the thermostat on a 2002 Mercury villager, pull the hose away. If the bolts do not come off, wiggle the fitting to expose the thermostat to be able to change it.
The 2.3 litre four cylinder engine in a ( 2002 ) Mazda B2300 has a timing CHAIN
Mazda did make a 1993 b2300(it was a b2200 or b2600).However the answer is follow the upper radiator hose to the block near the valve cover.The upper radiator hose connects to the thermostat housing.Easy.
change the thermostat
2002 Suzuki gran vitara
Mazda did make a 1993 b2300(it was a b2200 or b2600).However the answer is follow the upper radiator hose to the block near the valve cover.The upper radiator hose connects to the thermostat housing.Easy.
To change the thermostat on a 2002 Montero Limited, drain the radiator halfway through the plug on the bottom. Remove the upper hose assembly and unbolt the thermostat. Install the new one and fill the radiator.
To change the thermostat in a 2002 Nissan Xterra, remove the bolts that hold the cooling fan in place. Lift the fan out of the vehicle and loosen the clamp holding the lower radiator hose to the thermostat housing with a wrench. Remove the thermostat out of the mounting and replace.