i dont know Does anyone know how to change the brakelight on a ridgeline
Check the fuses for the trailer wiring.
short circuit on trailer light wiring
most buzzers are located on the driver side up underneath the brake pedal
No it is not. They changed the wiring in 2007, it is no longer "plug and play".
The Control Unit and Harness are strongly recommended if you are going to tow anything that requires lights/brake controls. FYI, you don't have to get HONDA control units, most businesses that sell trailers sell various name brands and can do the wiring for you. Anyway, the wiring for the taillights and brakes lights of the vehicle are not strong enough to carry enough power to supply the electrical on a trailer (very dim-could cause a short). The Harness connects a power source (battery) to the trailer wires. The Control Unit is connected to the vehicle wiring as well as the Harness. When you step on the brake pedal, the Control Unit senses it and allows the power to go to the proper wiring on the trailer directly from the power source, therefore you will have brighter lights on the trailer. The same for parking and turn indicators. This is worth the money. I have this set up on my 2003 Odyssey.
trayor brake control is pluged in were is the brake wire fro the tralor cant find it in harnes were do i look
Brake pedal switch, wiring, bulbs, bad trailer harness (if there), fuses...
http://www.wirediagram.com/honda.htm
Vehicle side, Brown, running lights Yellow, left signal/brake light Green, right signal/brake light Black, ground Trailer side, white is ground
In the floor cover behind the drivers seat (turn the knob on the cover & lift it out) you'll see some inline fuse holders in the wiring harness........... one of them is the trailer brake lights Good Luck !!!
Check all fuses first, check the brake switch located under the dash above the brake pedal. If you have a hitch on the car check the trailer wiring harness.