0
Add your answer:
Earn +20 pts
When was Nissan Quest created?
Nissan Quest was created in 1993.
Does a 1998 Nissan Quest have a timing belt or chain?
The 1993-1998 Nissan Quest has a timing belt.
Does a 1993 Mercury Villager have a carburetor?
Yes, the 1993 Mercury Villager was a 1992 Nissan Quest. The last year Nissan used a Carburetor on a Quest. Fuel injection system replaced the carburetor in 1993.
Where do you put water in a 1993 Nissan Quest?
In the radiator Mr.brown
Will the engine in a 1993 Nissan quest fit in a 1993 Nissan truck?
If the 8th VIN digit is the same on both cars, then yes.
Why does the Odometer on a 1993 Nissan Quest stop working?
The odometer on a 1993 Nissan Quest will stop working if the sending unit has failed. When a signal is not received from the sensor, the odometer is unable to properly update.
What is theTorque specs for axle spindle nut for 1994 Nissan Quest?
The torque specs for the 1993-2002 Nissan Quest FWD is 203 Ft-Lbs or 275 Nm.
Why the air conditioner not working on a Nissan quEsT 1993?
Nissan acIt needs to be rechaged, or the electrical wiring is off on the a/c motor
Where is the fuel filter located on a 1993 Nissan Quest?
On the right side(drivers side) right in front of firewall
How do you repair the heater blower motor on a 1993 Mercury Villager?
Is it really the same as the Nisan Quest? Anumber of parts are the same.
Is the 3.0 liter engine in a Nissan Quest a non-interference or interference type engine?
According to the history of the Nissan Quest Vg30e engine from 1993 thru 1998 these group of engines were non-interference engine, so if the belt breaks it will not damage the valves. This feature was demanded by FORD from Nissan before FORD agreed to used this engine in their ViLLAGER and Nissan Quest vans in the time of their joint venture.
How do you change the ignition switch on a 93 Nissan quest?
Begin by removing the retaining ring at the top of your 1993 Nissan Quest ignition switch. Slide the ignition barrel out. Remove the wiring harness from the end of the ignition barrel. Reverse the process to install your new ignition switch.
