0
Add your answer:
Earn +20 pts
On a 1995 Nissan 240sx which way do you face the thermostat in the housing?
up Spring towards the engine.
Where is the thermostat on a 95 Nissan 240sx?
Try the engine end of the upper radiator hose in a removable housing
How do you know if your thermostat on your Nissan 240sx is bad?
your temp guage will sky rocket if its bad, you may even have coolant a coolant leak (comming out of the the housing of the thermostat). replacing it is easy and cheap.
Where is the thermostat located on a 1990 Nissan 240SX 2.4 motor?
The thermostat is located on the RH side (passenger side) of the engine, toward the front. A radiator hose goes into a housing. Looking down from the top, there are (normally) two sensors going into the housing. The thermostat is below these and the cover is held onto the block with three bolts. If you replace it, go with an original Nissan brand. It's worth any extra cost.
1996 Nissan 240sx check engine code 55?
Nissan 240sx
What was the first year of the Nissan 240sx?
The Nissan 240SX was brought to America in 1989.
Is a Nissan 240SX a Japanese car?
Yes it is, the Nissan 240SX was assembled in Japan and brought to America in 1989.
Driver window is out of alignment on a 95 Nissan 240sx?
Driver window is out of alignment on a 95 Nissan 240sx? what do i do
What do you need to remove to get to the thermostat on a 1989 Nissan 240sx?
you should just be able to follow the upper hose to the water outlet then remove the 2 screws holding it on and inside you should see the thermostat
Will the passenger window from a 1991 Nissan 240sx fit into your 1995 Nissan 240sx?
Nope, different body styles
What are the volt settings for a tps sensor 1992 Nissan 240sx?
Wat are the tps volt settings for a 1992 Nissan 240sx
Where is the thermostat located on a 1991 Nissan 240SX?
Find the lower radiator hose, which is under the top hose running from the left side of the radiator to the engine. The loswer hose should run into an L shapped housing which is bolted onto the motor. Remove the 3 bolts attaching the housing to the motor, the thermostat should be right there. When replacing the housing besure to use a liquid gasket or else you'll have a leak. If you look straight down on your engine it right below a little to your left of your cam gears, its that tube that sticks out and goes to the left and to down below into your radiator. The tube is connected to a metal thing, you have to take off the metal thing and the thermostat will be inside. where the bottom hose of the raidator connects to the engine. ok clear this up. At the lower hose is a sensor not the thermostat, the thermostat is located on the front of the block running vertical and just left of the water pump.
