Simply start the engine and let it sit, running, for about 15 minutes. In that time the water pump will have circulated all the coolant in the system and the air in the system (if any) will have migrated to the radiator. Carefully open the coolant cap, relieving the pressure in the radiator and then, if necessary, add coolant and re-seal the system with the proper cap, making sure it is in good condition.
There is a bleed screw on the thermostat housing. Remove the screw with the engine loose. Ounc you have pure coolant and no air you can close off the bleed screw.
There is a bleed screw on the thermostat housing. Remove the screw with the engine loose. Ounc you have pure coolant and no air you can close off the bleed screw.
You can use any commercial coolant for automobiles or Honda's own coolant.
probably low on coolant, add coolant and bleed system. easiest way is to open coolant hose on top of engine and poor in one end til comes out other (will smoke slightly when you start, its ok, just burning off coolant). or have professional do it.
Trouble code P0128 means: Coolant Thermostat (Coolant Temp Below Thermostat Regulating Temperature)
The air bleeder plugs on a 2002 Saturn cooling system are typically located near the highest points of the system, such as near the radiator or on the engine block. They are used to release any air trapped in the system to ensure proper coolant circulation. Consult your vehicle's manual for specific locations.
there is none. look for the coolant expansion tank there is where you add coolant to the system.
Spongy or soft brake pedal usually means there is air trapped in the system. Bleed the brakes starting at the RR then LR > RF and ending at the LF.
The "bleeder screws" that come to mind are:Brake bleed - found at each wheel caliper / wheel cylinderEngine coolant - NOT found on a Windstar engine. Cooling system bleeding/burping is basically through just running the engine with the coolant reservoir cap off.
Your ''KIA'' dealer,or eBay
If This Is To Remove Air From Fuel Lines. Forget It. You Do Not Have To Bleed The Fuel Line.
pressurize the system