0
Add your answer:
Earn +20 pts
On a Pt cruiser how do you replace the power window light switch bulb?
The led light in the window switch is not replaceable. It is only serviced with the entire switch.
What is the multifuntion switch on a 2006 PT Cruiser?
It is the combination turn signal, high beam, head light switch.
Where is PT Cruiser dome light switch?
On the turn signal lever next to the headlamps switch. It's the one that controls the dashboard light brightness
Where is the fog light switch on the 2001 PT Cruiser?
The fog light switch is on the end of the turn signal switch. Just pull the end of the turn signal switch and the fog lights will come on. (Turn signal switch and fog light switch are one assembly)
Where is the brake light switch located on a 1988 Toyota Land Cruiser?
It is behind (and touches) brake pedal.
Where is the fog light switch in a Peugeot 106?
The fog light switch on my peugeot 106 is next too the hazard warning switch and the rear window heater switch below the stereo.
Why do your light stay on on your 2005 Subaru Outback?
Brake lights? Check brake light switch for adjustment or replacement
Where does the replacement brake light switch mount on an 89 Jaguar?
The B.O.O. switch or Brake On/Off switch is located at the top of the brake pedal assemble.
How do you tell if the window regulator motor or switch is bad?
Use a test light to see if the motor is getting power. If it is then motor is bad. If it is not getting power "jump" the wires on the switch to see if window will operate, is so switch is bad
Can you turn on the light house in point lookout in fallout 3?
Yes, if you find the crashed truck, you'll find a replacement bulb. Replace the bulb and switch the light on using the switch on the wall.
Stop light not working on an 1981 Mazda RX7?
We found the relay check lamp was the problem after replacement of vehicles stop light switch.
How do you jumper the window switch to get the window to come go up on a 1991 Ford Aerostar?
If you press the switch and hear the motor running, the the gear kit needs to be replaced. If you do not hear it, look at the dome light and see if it dims when you press the switch. If it does then you have a bad motor.
