0
Add your answer:
Earn +20 pts
Cps sensor 1989 Jeep Cherokee?
The camshaft position sensor is inside the distributor. The crankshaft position sensor is in the top of the bell housing on the driver side.
Location of a cam sensor on a 1989 Oldsmobile delta 98 3800 v6?
The camshaft position sensor is located behind the water pump pulley. If looking directly at the pulley, it is at about the 10 O'clock position. TechJK ---------------------
Where is the camshaft position sensor on a 3.8L 1989 Pontiac?
the sensor is mounted to the timing chain cover, directly beneath the water pump. has one 10mm. head bolt holding on. located by tracing 3-wire pigtail to it.
Where is the camshaft sensor on a 1989 olds ciera 2.8L?
There isn't one on that engine. Only a crankshaft sensor at the back of the engine.
Where is the crank sensor on a 1989 Pontiac sunbird 2.0?
Crank sensors are always located on the camshafts. The 1989 Pontiac Sunbird crank sensor is located on the head of the engine towards to end of the camshaft.
Does a 1989 Toyota pickup have a crankshaft position sensor?
Yes
Where is the throttle position sensor located on a 1989 Ford Aerostar?
The throttle position sensor is located on the throttle plate, straight across from the throttle linkage.
How do you replace the knock sensor on a 1989 Toyota supra turbo?
the knock sensor is located on the driver side of the engine right under the intake it is about 1 in. it is connected so you will have to unplug it and then just screw it off
Where is the location of TPS sensor in Honda civic hatchback 1989?
The Throttle Position Sensor is located on the throttle body
Where is the crankshaft position sensor located on a 1989 Mitsubishi Montero?
Inside the distributor.
Where is the camshaft sensor on a 1989 Buick LeSabre?
it should be behind the water pump pulley on the lower left side when looking at it from the side of the car.
What does the camshaft interrupter on a 1989 Buick Lesabre do and where is it located?
It should be behind the camshaft postition Sensor in the timing box attached to the end of the CamShaft. It allows the computer to know where the cam shaft is in order to properly inject fuel to the proper valve at the proper time.
