Re-filling your 1898 1.0 Micra gearbox is achieved by removing the speedometer drive cable from the rear of the gearbox adjacent to the startermotor solinoid, it is held in place by 1 x 10mm bolt.(It is tricky to get access to) Re-fill with 3.3 litres of fresh 80W90 gear oil after draining, and replace the speedo drive cable. Some 1998 onward models already changed to a different filler plug located much lower down in the gearbox housing and far easier to locate and access. It can be recognised as a round plug requiring a 3/8 inch square drive ratchet wrench to remove / re-tighten. Similar looking to the drain plug which requires a 1/2 inch square drive ratchet wrench to release and re-tighten. It is located toward the front of the engine about 4 inches from the bottom edge of the gearbox close to the drain plug.
There is a filler level plug, You'll need a 12mm allen key for that. It is located on the front face of the gearbox casing, next to the reverse light switch.
On side of gearbox ,is a screww plug with hex recessed into head
If you are referring to the automatic transmission - - looking at the engine compartment from the grille area - it is way down on the lower left side of the engine. Look hard and you'll find the dipstick and filler tube down there.
manual for gearbox for trition 1998
They are 165mm size
The 1993 1.5 liter Honda gearbox is different than the 1998 1.5 liter Honda gearbox. The gearboxes are not interchangeable.
Louis Filler died in 1998.
You don't it is a sealed unit.
You have stumped the wizzard as I find no such animal.
yes...????
its chain driven mate its chain driven mate
very carefully.JEW REPRESENT!!! very carefully.JEW REPRESENT!!!