answersLogoWhite

0


Best Answer

in my 1983 caprice..you have to take off the screws inside the trunk against the wall closest to where you are standing when you open the trunk...there should be about four rubber screws...and if you stick your head inside and look into each corner closest to you...there should be about 3 metal screws on each side...take those off...and once all the srews have been removed...you should be able to slide off the whole piece that contains the rear tail lights and turning signals...replace them as you normal would by turning the bulbs to the left...pulling them out...and placing a new bulb inside..

User Avatar

Wiki User

16y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

18y ago

Take the screws out of the lenses, remove the lense and replace the bulb.

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace brake light on 1981 caprice?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What size tires fit on a 1981 caprice classic?

Kindly tell, what is P.C.D of stock Rim of chevrolet caprice classic 1981


What is the bolt pattern of a 1981 caprice classic?

5 x 4.75 or 5 x120, atleast that's what it is on an '88 caprice


Why wont the gauges work in a 1981 caprice?

There is a fuse for the gauges, check it.


What could be causing the brake lights on a 1981 F100 to stay on when running and even when the ignition is turned off?

I got it. It was the brake light switch. No answers need now, thanks.


What are the ratings and certificates for Brake Tests - 1981?

Brake Tests - 1981 is rated/received certificates of: Australia:G


How do you center the valve in a 1981 Chevy C10 brake proportioning valve?

There is no valve inside. It purely restricts flow to the front so that the more efficient front brakes are not doing all of the braking. You will only find these on disc/drum combinations. If you are experiencing a brake pull, you need to replace either the front brake hoses or one of the calipers. If the brake warning light switch is leaking, the proportioning valve will have to be replaced.


How do you adjust brake light switch on 1981 pickup?

Need to know what make the 81 pickup is because some are adjustable and some are not.


Where is the brake light sensor located on 1981 Chevy pickup?

One may be located inside the master cylinder One may be located by the emergency brake pedal --upper end almost under dash


What fuse or link powers the high speed blower motor on 1981 Chevy caprice?

Near the blower motor there is a silver colored relay, follow the purple wire on the blower back. Replace the relay you should be good to go.


Why is the low fuel light on when fuel is full on MB 1981?

The sending unit in the fuel tank is defective,, replace it and fix your problem.


What is a 1981 Black Chevy Caprice worth?

$1500 +/- depending on milage, condition, history, modifications etc.


Where is the brake fluid tank in a 1981 Chevy Cheyenne truck?

The 1981 Chevy Cheyenne brake fluid tank can be found attached to the firewall in the engine compartment. The brake fluid tank will be on the drivers side of the firewall.