The towbar is not part of the factory equipment. YOU must purchase the towbar that has the correct drop for the trailer that you are going to be towing.
To remove the rivets that hold the ignition coil to the bracket: 1. Use a file or grinder to remove the head of the rivet on the bracket. 2, Use a suitable punch and drive the body of the rivet out of the bracket.
remove belt, remove alternator plugs, then bolts. pull out alternator. then undo bolts for bracket and remove.
A passat towbar is defines as a towbar that has been designed and built specifically for use on a Volkswagen Passat. They come in several different styles, depending on the need of the customer.
You will need a ratchet and a socket to remove it. You get under the rear of the truck and you will see the bolt and bracket holding the tire in place. Remove the bolt and the bracket hinges downward. You will need a ratchet and a socket to remove it. You get under the rear of the truck and you will see the bolt and bracket holding the tire in place. Remove the bolt and the bracket hinges downward.
I only fond a BMW z4 with a towbar in the Netherlands I saw the car and the towbar. The brand of the towbar is Westfalia. The car is for sell on www.autowalinga. nl
There are 3 wing nuts holding the headlight bracket. Remove these and unplug wire going to headlight. Remove bracket from van and then the headlight can be removed from bracket.
The best type of towbar for a Vectra is a self aligning tow bar, which is also the most common type. The best actual brand of towbar for a Vectra cannot be determined.
FIRST REMOVE THE WHEEL.THEN REMOVE THE TWO BOLTS HOLDING THE CALIPER TO THE BRACKET.THEN REMOVE THE TWO BOLTS TO REMOVE BRACKET. REVERSE TO REINSTALL.
remove the screws holding on the trim, remove the ashtray(should slide out) then remove the trim peice, then unscre the mounting bracket. Then unscrew the radio from the bracket and unplug the wiring harness.
Remove the third bolt !!
you have to remove the bracket that goes over the top of the battery then its just a matter of unbolting the hold down bracket and the cables