The door panel is connected to the door with screws around the arm rest area and then with white plastic fasteners that push into holes in the door. I started by taking out the screws that hold the armrest. The window switches and holder can be lifted by prying gently from the rear of the switch panel. The front has a plastic hook that fits into the arm rest so don't pry on the front or it will break. Only pry on the rear portion of the panel. You can use a butter knife to take the switch out of the switch panel That makes it easier to pull the door panel off. Once the screws were out, I used an old fork to pry the panel away from the door at each point the plastic fasteners insert into the metal. Just work at it and the whole panel will come off. These fasteners are around the outside edge of the panel. Once off you will see a plastic sheeting stuck to the door with a black tar type paste. Just peal it away from the door and you will be able to see the mechanism. You can undo the bolts that hold it to the door and also undo the window bolts that hold the window to the regulator. The whole regulator and motor assembly will come out as a unit and you can work on it from there. The reverse is used to replace it again. I have found that sometimes the small white fasteners get messed up. If they do you can by new at most automotive places. Hope that helps, I have had to replace all four regulators now on my 99 olds. CDH
remove the door panels
Remove door panels.. Unscrew old speakers..Screw in new speakers..replace door panels...ready 2 GO..
You don't need to remove front door panels, the speaker grills come out.
To remove the shift knob on the 1999 Olds Intrigue look for the pin that is holding the knob in place. Remove the pin and pull up on the knob, replace kob and pin.
You will need to remove the inner panels to gain access.
Remove the door panels and replace the speakers. They sit in baskets and are simple to replace. We have instructions at our enthusiasts forum. www.trailvoy.com
Remove all the screws, take the arm rest off, and lift.
Need to know how to remove the interior door panel so I can replace motor for electric window
To replace the front speakers in a Toyota Sienna the door panels must first be removed. With the door panels removed the speakers will be easily accessible and the mounting screws can be loosen. Unplug the speakers and remove them. Install the new speakers.
remove your door panel there will be three screws holding it on. then you have to remove the screws holding your window to the regulator. then unbolt regulator and motor from door. Undo wiring going to motor.
To change your rear tail lights on your Shogun Pinin you will need to open the back hatch. After you open the hatch you will see panels next to where the lights are. You remove those panels and you will see your light bulbs and be able to replace them.
To change the water pump simply remove the bolts from the waterpump, pull it off and replace with new. The power steering pump will need to be loosened and moved aside to remove one bolt. Clean old gasket from engine block and replace with new gasket and replace with new waterpump.