answersLogoWhite

0

To remove the cylinder head on an Astra 1.7 CDTI, disconnect the battery cable and remove the lower engine cover. Drain the cooling system and remove the oil filter. Remove the air filter hoses and disconnect the crank case breather hose from the valve cover.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

Cylinder head torque settings for vauxhall 1.6i?

Hi need the torque setting for a Vauxhall zaferia 1.6 head


How do you remove cylinder head from 1991 Mercedes Benz 190e 2.3?

how remove cylinder head


How do you take a head off on a 08 vauxhall vectra 1.9 cdti?

To remove the cylinder head from a 2008 Vauxhall Vectra 1.9 CDTi, start by disconnecting the battery and draining the coolant. Remove the intake and exhaust manifolds, as well as any accessories obstructing access to the head. Next, unbolt the cylinder head in the correct sequence to avoid warping, and carefully lift it off the engine block. Make sure to replace the head gasket and check for any damage before reassembly.


How do you change lifters on a 1995 jeep cherokee Laredo?

You have to remove the cylinder head(s) to access the lifters.You have to remove the cylinder head(s) to access the lifters.


Do you have to remove the cylinder head to change the head gasket?

Yes.


Where is the thermostat located on a vauxhall vectra 1.9cdti?

On the cylinder head (gearbox end), under the vacuum pump.


Where is the pcv valve on a vauxhall astra mk4?

PCV= Positive Crankcase Ventilation.It will be in the cylinder head cover.


What is the torque settings for vauxhall zafira cylinder head z16xe engine?

25nm then 3 x 60 degrees


How do you change head gasket on 1.8 L VW Passat engine?

Remove the cylinder head from your VW engine. Remove the head gasket and clean the head gasket surface. Put the new head gasket on and return the cylinder head to its original position.


Cylinder head tightening sequence for Vauxhall Vectra?

The cylinder had bolt tightening sequence should begin by tightening the head bolts on each end of the head. Tighten the center head bolts. Work towards each end of the head, alternating back and forth.


How do you remove a cylinder head?

Start with undressing the cylinder head inlet and exhaust manifolds get a container for bolts and any other small stuff undo all of the cylinder head studs and lift off the cylinder head.


Fix a Blown cylinder head gasket?

remove head and replace gasket :)