Open the center console and you will see two small bolts towards the front of this compartment(right behind the cup holder). Remove these bolts and the entire center console front of the open compartment should come right out. Now the bezel in front of the radio will snap right out(be careful not to break it especially in cold weather, it is just plastic and can break easily). Now there are just a few bolts that hold the actual radio in. Remove these and the radio will slide out and you can disconnect the wires and such on the back.
Take it to the dealer.
Remove the decorative stereo cover. Remove the stereo retaining screws. Pull the stereo out. Remove the wiring harness and the antenna cable.
Remove the retaining cover from your stereo. Remove the stereo retaining bolts. Slide the stereo out and remove the wiring harness. Reverse the process to install your new stereo.
Remove the decorative stereo cover. Remove the stereo retaining screws. Pull the stereo out and remove the wiring harness and the antenna cable.
I put an aftermarket system in my intrigue, and don't recall a "stereo accessory wire". Do you mean the power antenna wire? Or is this a wire on your aftermarket box? Here's a GM diagram: http://www.installdr.com/Harnesses/GM-Wiring.pdf
Remove the decorative cover from your 2006 Chevy Express stereo. Remove the stereo retaining screws. The stereo will slide out. Remove the wiring harness and the antenna cable from the back of the stereo.
Remove the cover from your 2001 Chevy Silverado stereo. Remove the stereo retaining bolts. Remove the wiring harness and the antenna cable from the back of the stereo.
Remove the decorative stereo retaining cover. Remove the stereo retaining screws. Slide the stereo out and remove the wiring harness and the antenna cable.
Remove the decorative cover to your 2001 Chevy Lumina stereo. Remove the stereo retaining screws. Slide the stereo out and remove the wiring harness. Remove the antenna cable.
remove the plastic panel around the stereo by using a flat screwdriver to pop it out in all corners then remove screws then remove stereo remove the plastic panel around the stereo by using a flat screwdriver to pop it out in all corners then remove screws then remove stereo
Remove the 2002 Dodge Durango factory stereo decorative cover. Remove the factory stereo retaining screws. Pull the factory stereo out. Remove the wiring harness and the antenna cable from the back of the stereo.
Remove the retaining cover from your factory stereo. Remove the factory stereo retaining bolts. Slide the factory stereo out. Remove the wiring harness and the antenna cable from the back of the factory stereo.