Sometimes the heat shields around the outside of the converter break loose or rust out and causes a rattle noise.
Only if its done right. Sand down to bare metal. Spray with the rust converter and then repaint.
The best solution to rust a nail is to apply a rust converter or a rust inhibitor. This will help to neutralize the rust and prevent further corrosion. Sanding the nail to remove the rust and then painting it with a rust-resistant paint can also be effective.
Try coating the rusted areas with rust converter and repainting wit a suitable paint.
soda does not make iron rust ...
To repair rust damage, start by sanding down the affected area to remove the rust. Next, apply a rust converter to stop further corrosion. Finally, use a primer and paint to seal and protect the metal surface.
There are material available that convert rust and stop it from spreading. In Australia it is called rust converter. Tel your hardware supplier what you are looking form and I am sure he will guide you to it.
soggy and wet conditions can make metal rust
pennies don't rust!
rust=air+metal
The best way to remove rust from steel is by using a rust remover solution or a rust converter. Sanding or wire brushing can also be effective in removing rust, followed by applying a rust-inhibiting primer to prevent future rusting. Remember to wear protective gear and work in a well-ventilated area when handling rust removal chemicals.
That doesn't make any sense rust is iron oxide