Mazda 626 LX 4 Cylinder specifically, but this should work on all similar models. Remove the battery cable COMPLETLY. Loosen large inlet and outlet hose clamps and 2 13mm OD nuts and 1 bolt on the air clearner housing. Disconnet both air and temperature sensors from that housing. Set it aside. Turn wheels fully to left and jack up the car on the passenger side and block (wheels to). The starter motor is located 'neath the intake manifold (that spider looking thing on the back of top of the engine. Use swivel adapter or socket, 14mm to remove the top 2 bolts. Ensure you remove the bolts as the wire harness is held in place by the back one. The bolt go through the transaxle and thread into the starter. Slide underneath from front and remove the 2 14mm bolts on the bracket directly behind the starter motor. Remove the last starter bolt, easiest using a 30 inch 3/8 drive extension through the passenger side suspension. If you have the extension, you can remove the starter motor terminal nut (14mm) and slide off the loop lug. Reach up over the motor housing as you remove it to squeeze and remove the solenoid connector clip. If you don't have the cool extension and can't put a bunch of shorties together, pull the starter back and face the back down to remove the heavy wire lug. If you can't do it with these directions, you are a rock and should pay. Jim
how to change starter
To change the starter on a 1998 s10, the motor mount will have to be removed. Support the motor on a jack with a board on the top of it, and remove the mount to get to the starter.
You can find the starter on the right hand side of the motor. The starter will be near the back of the motor. You can follow the positive battery cable to the starter.
how to change starter 2.0 diesel zafera
Change starter 1996 Audi a6
Follow the positive (+) wire from the battery it goes straight on to the starter motor.
how to change starter on Hyundai scoupe 1993 12 valve
what needs to be remove before you change
i believe the solenoid is part of the actual starter motor. you have to change the whole starter.
disconnect battery. from underneath disconnect solenoid wire and battery cable from starter solenoid. remove starter motor bolts. remove starter motor. installation is the reverse but be sure to place the starter shim between the starter motor and the engine or you will get noise during starts.
35mins
You can find the 1991 Nissan starter motor relay switch in the fuse box. The starter motor relay switch will be in the third column, second from the bottom.