0
Add your answer:
Earn +20 pts
How do you know if your pass time device has affected your car starting?
depends on times you have had it
How do you disconnect sequoia power antenna?
remove the pass. finder linner and find plug to the motor and disconnect it
How do you disable an anti theft device on a 1996 Pontiac Grand Am?
Remove the fuse if the device is on a dedicated circuit. Otherwise, disconnect power to the device.
Does 32 bit diagnostics result pass when the device is not working fine?
no, if the device is connected fine and 32 bit diagnostics are run. It will not pass for a faulty device.
Is pass time the same device as on time?
it actually just means the number like 2 o clock means the second one
What does it means when idpod says do not disconnect?
That's the meaning of Do not disconnectWell... Just don't disconnect. Or you interested in the reason also?? Bah... So, if you connect your mobile data storage device (such a pendrive or an iPod) the device doesn't know, when will the data flow. If you disconnect your device, while it is written, the data will be damaged. It's because of Windows. If you enable fastwrite (or something similar, I don't use English Windows), the system won't write the datas into the iPod in real-time, instead it will write it later, or (if you run a lot of CPU "eater" programs) before you disconnect your device with safe unplugging (you know, with the green arrow beside the clock). It's because that windows can manage the CPU time more effectively (in theory :) ), if it doesn't have to write the datas immediately.
Did 911 firefighters use the PASS device?
The short answer is yes. ALL SCBA's are required to have a PASS device as per NFPA standards.
How do you disconnect a pass time of a car?
Find the pass time under the dash or wherever it is by following the remote sensor eye to the box. There is a five wire plug attached to the pass time device. Disconnect this plug. You can take the pass time out now but your car wont start. To solve that, cut the purple and the blue wires from the plug you just disconnected. Strip the insulation off the ends and twist and solder them together. You can use a crimp if you'd like too but solder would be better. Wrap electrical tape over the exposed splice. Cover the end of the plug with tape as well just to be safe. Tie the wires out of the way with a cable tie and put whatever you took apart to get to it back together. You are then done. If you want to simply disable the device from affecting your starter but leave it in the car so that it will still take codes and "appear" to be working, then leave the device plugged in and just splice the purple and blue wires together as before. It's probably illegal to do this unless you have paid off you car, so I'd check that first. If your car is paid off chances are the dealer will remove it for free if you ask since he could then reuse the device and they do cost more to buy than to pay to have removed and installed.
True or false A device that is used to open the circuit when the current flow is to great is a disconnect switch?
False. A device that is used to open the circuit when the current flow is too great is a circuit breaker or fuse.A disconnect switch is a manual device that isolates or turns off the load.
How do you disconnect power?
By unplugging the device in question or turning off the breaker for the fixture in question.
What is the importance of an electrical switch?
It allow you to disconnect power to an electrical device with the flip of a switch.
Why doesn't Mobogenie connect with my phone?
(1)Disconnect your device (2)Check if the device is switched to USB Debugging mode (3)Connect again
