# Let the engine cool down enough so you don't burn yourself on the coolant. # Loosen the clamps on either end of the hose. # Pull of the damaged hose. # Clean the tubes where the new hose is about to be putt. # Put the clamps over the new hose. # Slip the hose over the tubes that the old hose came from. # Firmly tighten the hose clamps. # Remove the radiator cap. # Fill the radiator with coolant. # Replace the radiator cap. # Fill the coolant reservoir to the recommended level and replace the cap, Viola all done.
if you dont know how to change out a water hose your an idiot!!!!
1. Open the radiator cap. 2. Disconnect the top radiator hose. 3. Run the engine for a couple of minutes with the hose off. 4. Insert tap water hose into the radiator where the top hose should be. 5. Run water into the radiator until clear water comes out of the radiator top hose. 6. Continue idling the engine, remove the tap water hose from the radiator, shut off engine as soon as the water stops coming out of the top water hose of the radiator. 7. Reconnect top water hose and fill radiator with antifreeze. Start engine and top off antifreeze.
The thermostat on a 1992 LeSabre should be inside of the top radiator hose inlet. You can easily change it by removing the top hose and water inlet.
You can run water uphill with a garden hose by decreasing the size of the hose as it moves away from the water source. By decreasing the hose size, pressure in the hose increases and the water will travel uphill.
How do you change front brake hose on a 1997 lincoln
drain the radiator, disconnect the radiator hose from the water pump. disconnect the water pump. lay down the seal connect the new water pump. connect the hose back to the radiator. its pretty easy
follow the top radiator hose to the engine. its under the cover where the hose attatches
You may need to change the thermostat. Follow the top radiator hose to the engine, it is under the cover that the hose connects to.
Can you be specific? If you mean a garden hose, then basically water is let into the hose and pressure forces the water out.
If the end of the hose is running in a pool of water, yes
The thermostat is inside of the water inlet on top of the motor. Disconnect the top water hose, then unbolt the water inlet. The thermostat can then be changed.
the used of water hose is to shower the plant or anything