Lock the engine by removing the starter motor and using a flat bladed screwdriver placed in the teeth of the ring gear. If you have an impact driver and relevant hex bit give that a try while someone holds the screwdriver in place. This may not budge the bolt so in my experience the best way is:
Using a cold chisel hammer the bolt to turn it anti clockwise, you will need several good hits with a large hammer, this method will damage the bolt but it is important that it is replaced anyway as it can only be torqued up once.
What tools do you need to remove the crankshaft pulley on a 1995 Honda Passport?
Depending on engine displacement in general remove belt-s then bolt holding pulley to the crankshaft then using a puller remove the pulley, when installing use a installer not a hammer to put the pulley on the crankshaft.
u need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removalAnsweru need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removal Answeru need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removal
The crankshaft pulley unbolts from the harmonic balancer. The harmonic balancer can be removed from the crankshaft with a 3 bolt puller.
Hello! The crankshaft position sensor is located behind the crankshaft pulley,on the left side facing the front of the car.It is difficult to see and to remove it you need to remove the crankshaft pulley ( radiator,belts,.... )
Remove crankshaft pulley& ballance
Disconnect the battery and remove the fan assembly and crankshaft belts. Remove the center bolt from the pulley and use a crankshaft pulley remover to pull off the pulley. You can usually borrow one from an auto parts store.
1998 Nissan pathfinder crankshaft pulley bolt is right handed.
Depends on what type of vibration damper (crankshaft pulley) you have. Your local auto parts store probably has the one you need and can rent it to you.
Remove bolt, and use a harmonic puller to remove pulley.
no
Counter clockwise