0
Add your answer:
Earn +20 pts
Where is the cam shaft sensor on a 1997 Chevy 305?
It is in the Distributor.
Will 92 park avenue start with bad cam sensor?
No it will not start need to change the cam sensor & crank sensor!
Where is the cam shaft sensor located on a 96 gmc serria 1500 pickup with 305 vortec motor?
Inside the distributor.
Where is the cam sensor on a 1998 wrangler?
The cam position sensor is inside the distributor. There is a wire harness that exits the side of the distributor. That's it. You have to remove the distributor to change that sensor.
2006 F150 Cam Sensor lacations on the 5.4 Triton?
OOPS! The cam sensor is on the front of the head, where it's safe and where you can change it easily !
What is the difference between a camshaft angle sensor and a camshaft positioning sensor If there is any?
have never heard of a cam angle sensor. the cam does not change angle.it stays put in the bearings
How do you change a camshaft sensor in a 98 dodge stratus with a 2.5L V6 slapstick engine?
The cam sensor is part of the distributor, the entire distributor needs changed. You can not get the cam sensor separately.
Can you change your 2 barrell setup for a 4 without changing the cam in your 77 Camino 305?
yes
Where Cam shaft sensor 1992 riviera buick?
Both the CAM and Crank sensor are on the front of engine. The cam semsor is to the right and held in with two smaller screws. It is actually a sealed Hall Sensor device but pretty easy to change.
How much horsepower does a cam add to a 305?
Depends on the cam.
Does a Chevrolet 2.2 have a cam position sensor?
The 94 and 95 are the same,no cam sensor.1996 and 1997 are differant in one way.The 1996 and 1997 have a cam sensor. .The 97 has a cam sensor and the 94 does not.The 1996 has a cam sensor too.
How do you change a cam shaft sensor shaft?
Most cam sensors are attached with a single bolt. just a matter of locating the sensor, removing the wire to it then unbolting it. Refitting is the reverse of the above.
