Defective ignition switch.
That means you ignition is lock but its not a BIG problem. Just unlock it.
first you pull the plastic rod then turn on the ignition
It sends a power to the starter relay/solenoid to engauge the starter. Know that the ignition switch is not what you put the key in and turn. That is the lock assembly. The ignition switch is located lower down on the steering column.
You turn on power to the accesories, ie radio, power outlet, etc.
Ignition switch 2002 Chrysler sebring. Original key will not turn? Is there a fuse or replace the switch?
How can I take out the key from the ignition key in a BMW 325i 2001. I can turn on the engine but the key doesn't come out when I turn off.
Remove steering wheel, turn signal (4 screws), and torx holding ignition, reverse to reinstall.
Then you have a corroded or loose cable connections or possibly a defective starter. Another possibility is a defective ignition switch. I am assuming the engine will not turn over.
Either something is wrong with the key or there is something wrong with the switch. You can try to spray some WD-40 or something like it into the switch and wiggle the key to see if you can get it turning. Otherwise you may have to replace the ignition switch.
sounds like u need to change the ignition switch itself ( the keybarrel)
Ur life suck that why
change ignition switch and/or tumbler
Yes, the ignition switch must be in the ignition position -not- the accessory position.
Set the multi-information display to TRIP A. Turn the ignition switch off. Press and hold the ODO / TRIP switch, and turn the ignition switch on (IG). After turning the ignition switch on (IG), keep holding the switch for at least 5 seconds.
Defective ignition switch.
99 jeep Cherokee Laredo stay running after turn off the ignition switch?