If you are talking about the lamp then the answer is no. If you are talking about the fluorescent fixture, it should be. It is the fixture grounding that helps the tube to ignite. because of the close proximity to the metal of the fixture. There are many occasions when the fixture will not operate, but as soon as the ground is connected the fixture operates fine.
Yes a black lamp tube will work in a fluorescent fixture. Guess you don't remember the early 70's.
Will your lease be up then? As I understand the state laws, a landlord may terminate a month-to-month lease agreement for any reason if he/she gives you at least 30 days' notice. However, a landlord may not evict you or terminate a lease early unless you're not paying rent or have in some way violated your agreement. I'd talk to my attorney first, but I think I'd end up letting him try to evict me in court if this is going to be his approach to renting to people. If the landlord tells you 30 days before the lease ends that he's moving in at the end of the lease, then you'll want to move out. Again, this is my sense after reading our state landlord-tenant law, however I'm not an attorney and you may want to consult one before tackling this on your own.
There is no predicate noun (also called a subject complement) in the sentence, "The electrician installed the light fixture?"A predicate noun is a noun or a pronoun that follows a linking verb, restating or renaming the subject.Example: The electrician is my brother. (electrician = brother)
The voltage can be any voltage that you like or what is available. It is the specifications of the light fixture that defines whether it is suitable to be used in a confined space. One has to know what the environment is in the confined space before a light fixture can be chosen. The environmental conditions can be any one of a number of conditions including explosive gases. With explosive gases present, the wiring and devices within the space must all be explosion proof equipment.
A fancy light fixture may be called a chandelier(originally a hanging candelabra).
The light is wired the same as any voltage fixture. Bring the source voltage to the fixture and connect it to the two fixture wires. If you want to control the off-on of the fixture take the source voltage to a switch first and then out of the switch to the light fixture.
Take the nut off at the bottom of the light fixture by unscrewing it.
The tenant of Stadium of Light is Sunderland A.F.C. in England.
Yes, you can connect a wall switch to an existing light fixture by running a new electrical wire from the switch to the fixture. This allows you to control the light fixture independently of the existing fixture. It is recommended to consult a licensed electrician to ensure proper wiring and installation for safety.
Disconnect the fixture wires and remove the central mounting nut to release the dome from the light fixture in a ceiling fan.
A chandelier is a decorative light fixture that hangs from the ceiling and typically has multiple arms with light bulbs.
A fixture or device that holds a light in place by means of some sort of socket, that is connected to a power source.
The tail light lens on a 1989 Chevy Celebrity is part of the tail light fixture and cannot be conveniently removed. If you want to change a light bulb you have to remove the tail light fixture from the car. To remove the tail light fixture: 1. In the trunk next to the quarter panel are three nuts, remove the center nut. It should be in the center of the tail light fixture. 2. Pull the tail light fixture so that the stud comes out of the body, then pull outward to pull the tab out of the backup light fixture. 3. You can now take the appropriate socket out and replace the bulb. Reverse the steps to replace the light fixture.
A pin based fluorescent light fixture is the type of fixture that takes fluorescent tubes. On each end of the fluorescent tubes there are contact pins. These pins are used to hold the tube in the fixture and to supply the voltage to the tube from the fixture's ballast.
A marble light is a light fixture made of marble.
The fixture construction has nothing to do with the amount of energy that the fixture uses. It is the lamp in the fixture that draws the amperage. This amperage times the fixtures voltage is what gives you the fixtures wattage. W = A x V. Watts = Amps x Volts.