Look at the lower section of engine - follow + battery cable
The 1992 Chevy 3500 temperature sensor is located on the front of the engine. The temperature sensor will be in the vicinity of the thermostat housing.
This vehicle (like most cars) has both a starter and an alternator. The alternator is driven by a serpentine belt, and the starter is located on the lower part of the engine at the transmission, where the teeth engage with the flywheel/flex plate. An alternator for the 1992 Sentra usually costs around $120-150, and a starter in the range of $90-120.
Yes, it is built on the starter.
If you don't have spark at the plugs, or at the distributor cap, the problem is probably a faulty ignition module. This is located under the distributor cap and ignition rotor. You need test equipment to check the coils, modules and pole pieces.
1992 Chevy trucks did not have a CAM SENSOR. They had a distributor.
how do you replace a CV joint on a 1992 Chevy pickup?
Inside the dashboard, to the right of the glove box.
Backside, lower, passenger side of engine.
inside starter.
You either have a shorted out starter are the starter wires are shorted out.
the fuel pump on a 1992 Chevy pickup is located inside the gas tank but is attached to the top side of it. you have to drop the gas tank to get it out but up want to make sure that there is not much gas in there when you do it because it will be extremely heavy if you don't.
about 3 hours
The starter solenoid is attached to the starter.
were is athe fusbla link located on a 1992 Chevy s10 IT'S LOCATED JUST ABOVE THE STARTER AND CELINOID. THERE'S 2 OF THEM THERE.
Where is the AC sensor located on a 1992 GMC pickup
between starter housing & block