There are to oxygen sensors on a 2004 Chrysler Sebring. They are located on the right side of the engine, against the firewall. Sensor 1 is located in front of the catalytic converter, and sensor 2 is located behind it.
It is a sensor that reads the rotational position of the camshaft. The engine computer uses that to control ignition and fuel timing.
A person can get a 2004 PT Cruiser engine diagram from a Chrysler dealership. An auto parts store also may have a copy of the diagram for customers.
The gas cap is loose or there is a large vapor leak in the fuel system.
Did you ever have a coolant leak?
If you have it done by a dealer, probably around $200. The alternator itself can be purchased for about $80.00, but, if you don't know how to install it yourself you can expect to pay for an hour labor. Depending on the shop that can run from $50.00 to 100.00 per hour.
No, it shouldn't.No, it shouldn't.
Chrysler PT Cruiser was created in 2001.
The external air temperature sensor on a Chrysler PT Cruiser is located in the front of the motor. It is in the air intake tube that goes from the air cleaner to the motor.
No. The Chrysler PT Cruiser was stopped in 2010.
No. The Chrysler PT Cruiser was built from 2001-2010.
Replace both of them.
Chrysler manufactures the PT Cruiser
It is on the engine, just below the radiator cap.
cost me $200 , which included camshaft sensor
The crankshaft position sensor on the PT Cruiser is on the side of the engine above the oil filter. The sensor is removed with two screws. Unplug the wiring, remove the bolts, then install the new sensor.
There are two screwed into the exhaust on the rear of the engine .
In the front under the starter you have to get to it from under the car