You need to be more specific. Like what year and what engine. Either a base SOHC (97-99), a NA DOHC or a twin turbo (91-99). The DOHC models have a front and rear sensor on each manifold. The rear is s pain in the @$$ to get off. The SOHC has one sensor located under the car near the flex pipe in the front. It runs into the car up into the shifter area. Hope that helps. Be careful with the install and make sure the wires aren't touching any metal when you plug it in. I made that mistake and when I started my car I blew my ECI fuse.
It is a sensor with 2 wires going into it located between air filter and throttle body.
The IAT sensor (Intake Air Temperature) is an integral part of the Mass Air Flow sensor.If the IAT sensor must be replaced,you must replace the MAF sensor
The engine ECU are located under the center of the instrument panel.
NO, MOTOR MOUNTS ARE DIFFERENT, NO ROOM FOR THE INTERCOOLERS, NOT ENOUGH SPACE FOR THE EXHAUST SYSTEM, WOULD BE EXTREMELY EXPENSIVE TO DO!
The overdrive solenoid on the 1984 Celica GT is located inside the transfer case valve body. The solenoid can be accessed by removing the transfer case pan.
there is no crank sensor on a Mitsubishi 3000 gt but there is a crank angle sensor that looks just like a distributor its in the back of the engine on top between valve covers
Bung in the exhaust manifold.
On top of the transmission, near the clutch slave cylinder.
Screwed into the exhaust pipe
In front of the catalytic converter on the passenger side
Bank 2 is the drivers side of the engine , sensor 2 is in the exhaust pipe after the catalytic converter ( downstream )
it is located behind the radio
bank 2 is the drivers side of your engine sensor 2 is after the exhaust has passed through the catalytic converter ( downstream )
Two, an upstream and a downstream oxygen sensor.
The cost of an oxygen sensor for a 2000 Mitsubishi Eclipse GT will cost between $55 and $80. The difference depends on location, dealer, and brand of sensor.
Depends on the year of the car. If the 3000gt is a 91-93 model then the oxygen sensor should be right before the catalytic converter sticking off of the exhaust pipe. If it is a 94-99 model then there will be one before the catalytic converter and one right after it as well.
the 02 sensor has nothing to do with gas mileage. it sipley is a sensor that reads the oxygen level in your exhaust for emissions.