answersLogoWhite

0


Best Answer

It goes to the temp gauge which is usually screwed in the head between the manifold on the drivers side, or into the thermost housing on the intake manifold.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where does temp gauge hook to block On 1985 350 Chevy?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where do you hook the oil line up for the oil gauge on a big block Chevy?

Right above the oil filter.


Where do you hook up the water temp gauge on a 87'chevy 350?

The most effective location for a water temperature gauge on a vehicle is on the head or the side of the block. Generally, water temperature gauges are more accurate and fit better in these locations.


Where is the fuse for the fuel gauge on 1998 Chevy blazer?

The fuse box for the fuel gauge on 1998 Chevy blazer is located on the driver side. It is near the hook latch.


Where is fuel gauge fuse on 1998 Chevy blazer?

The fuel gauge fuse on 1998 Chevy blazer is located in the front of the blazer. It is on the driver side next to the hook latch.


How do you connect a choke cable in a 1965 Chevy c-10?

how do you hook up a manuel choke on a small block chevy


How do you take the motor out of a 1985 Chevy Impala?

cut all the hoses and wires and hook a chain to it and rip it out.


How do you hook up a tach to a small block Chevy with HEI distributor?

On the dist., cap, where the wires go in, there is a tab labeled TACH.


Where do you hook up oil gauge on a 283 small block?

There is a 1/8 NPT threaded hole on the rear rail at the back of the block. There is also a 1/4 NPT plug just above the oil filter.


Installed a edelbrock 1406 carb on a 400 small block Chevy where do you hook up the transmission kickdown cable?

There are two excellent pdf's for this carb at summitracing.com.


What is James Hook's birthday?

James Hook was born on June 27, 1985.


How do you hook up a fuel level gauge on a 350 engine?

The fuel level gauge is in the tank


How do you hook up temp and battery and oil pressure gauge on a Chevy 350 1984?

The temp gauge sensor screws into the driver side head atoms #2 and #3 plugs. The volt gauge hooks up to any ignition on hot wire and the other wire to chasis ground. Oil pressure gauge is just behind the distributor.