answersLogoWhite

0


Best Answer

we can drive shaft run out thriugh the dail indicator.

1. put the dail indicator at shaft

2.checking

3.marking at 4 section. 0 , 90 ,180 ,270

4.chek clearance

5.check bearing surface

6.check earw ring

check shaft cracking

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is drive shaft run out?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can you run 1997 jeep xj with front drive shaft out?

Yes


Who invented the drive shaft and when?

A drive shaft allows torque to enter a motor. Louis Renault of France was the inventor of the drive shaft. He invented the drive shaft in 1898.


Drive shaft and intermediate shaft the same?

is the drive shaft the same as the intermediate shaft on a vauxhall corsa car does any body no


Is the drive shaft part of the transmission?

The drive shaft is part of the drive train, not part of the transmission.


How do you replace drive shaft on 1990 Toyota Camry?

tool for drive shaft


Is Drive Shaft a real band?

Yes Drive Shaft is a real band.


The drive shaft connects the transmission to the?

The drive shaft connects the transmission to the differential.


What does drive shaft repair cost?

F150 4x4 drive shaft balanced


How do you remove a drive shaft in 1999 Ford Taurus?

there is no drive shaft it's front wheel drive


What is the purpose of a dry shaft in a car?

there is no dry shaft oly a crankshaft in the engine and the drive shaft that moves the car the drive shaft is connected to the transmission and the rear axle if your car is front wheel drive ypu do not have a drive shaft just a transmission and two axles


How do you remove the drive shaft on a 1999 Ford f150 Ford?

Chock the wheels to be sure vehicle will not roll. Mark the differential and drive shaft before removing drive shaft. Remove 4 bolts from differential-end of drive shaft. Place a pan under the transmission-end of drive shaft and have clean rags handy. Push the drive shaft slightly toward the front of the vehicle while pulling downward on the drive shaft and lower it to the ground. Pull the drive shaft toward the rear of the vehicle until the front of the drive shaft pulls out of the transmission. Place the drive shaft on the ground and put rags in the transmission to prevent oil leakage and keep dust/dirt out. Assemply is reverse of removal with special attention to aligning marks on the drive shaft to the mark on the differential.


Can you shorten the drive shaft to fit a longer shaft on the transmition?

this requires a drive shaft company that can cut and weld it and balance it after.