You can find the map sensor behind the passenger side dashboard. You will need to remove the glove box in order to access the map sensor.
Replace sensor and clear code.
it took me quite a while to figure this out myself. it's a current problem on my car. It is on the drivers side of the upper intake manifold. Below the EGR valve.
The purpose of a MAP sensor is to monitor the pressure of the intake manifold by automatically adjusted the amount of air or fuel being taken in. Symptoms of a bad MAP sensor include poor gas mileage, idling problems, and fouled spark plugs.
map sensor is located on the upper intake on the passenger side near the back.
The 1995 Oldsmobile Aurora cooling system temperature sensor can be found on the front of the engine. The sensor will be above the thermostat housing.
Don't think yours will have a MAP sensor. It will have a MAF sensor, and it is attached to the air filter housing.
how do i check the relay fuse for the fan on a 95 oldsmobile aurora
Bad sensor? Should be located at the bottom of the coolant recovery tank
is it hard to replace a waterpump out of a oldsmobile aurora 95
Where is the Knock Sensor located on a 1996 Oldsmobile Aurora?
I need to locate the IAT sensor on my 2001 Aurora
According to my Chilton manual, page 4-22, the MAP sensor is used on 96 thru 99 LeSabres/Bonnevilles/Eighty-eights, not 95's.
Aurora 3.5 - the sensor is on the front of the engine, on the right side, up behind the starter. You can see it from the bottom looking up, but you have to remove the starter to get it out. The Aurora 3.5 has a single dual sensor. The Aurora 4.0 has two separate sensors.
Where is the speed sensor located on a 1997 Oldsmobile Aurora
It uses a MAP sensor.It uses a MAP sensor.
im missing something on the top half of motor i think it is the map sensor 3.4l