answersLogoWhite

0

i dont think so i belive its all vacume controlled drive safe

User Avatar

Wiki User

18y ago

Still curious? Ask our experts.

Chat with our AI personalities

RossRoss
Every question is just a happy little opportunity.
Chat with Ross
LaoLao
The path is yours to walk; I am only here to hold up a mirror.
Chat with Lao
BeauBeau
You're doing better than you think!
Chat with Beau

Add your answer:

Earn +20 pts
Q: Is there a fuse for the cruise control on a C230 Mercedes?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

Where is the cruise control fuse on a 1994 Acura Integra and would that affect the dashboard clock?

There is no fuse for the cruise control on a 1994 Acura Integra. It is a relay switch under the hood near the battery. This would have nothing to do with the dashboard clock, if the cruise control is not working properly. If the cruise control is not coming on, check the relay, then check the carburetor or EFI (Electronic Fuel Injector). Also, the cruise control will not come on if the brake light switch or the clutch is not working properly.


Where is the AC Compressor fuse on a 2000 Mercedes C280?

The 2000 Mercedes C280 air conditioning compressor fuse can be found in the fuse box. The air conditioning compressor fuse will be in the second column, fifth from the bottom.


Fuse location 2002 Mercedes Benz e320?

The 2002 Mercedes-Benz E320 fuse box is located in the engine compartment. The fuse box will be on the drivers side of the engine compartment.


Where to find fuse box information for 1979 Mercedes 300SD?

I'm not sure about the location for your 300SD, but I have a 1979 450 SLC and the fuse box is located underneath the dash on the passenger's side -- to the right of where the passenger would place his feet. The fuse box diagram should be glued to the back of the door that opens to the fuse box.


How do you fix the cruise control if it is sticking in a 92 Chevy Van?

Often, the most difficult part of a repair project is the actual diagnostic phase in which youd etermine what's causing the problem. Without more information it is impossible to tell you what's wrong and what to replace. It can be the module, the brake sensor, switch, connector, speedometer, brake light ground fault or any of a number of other problems and it's impossible to tell you which it is without digging into the vehicle.