try removing the negative lead on the battery for about 30 min that will reset your computers
Chrysler Corporation does not install inertia switches in their vehicles. It is probable fuel pump, fuse, or relay.
No, there is no suck switch.
If you mean theft system activated, it can only be reset through computer by an auto locksmith or dealer. If light flashes when key is on, theft was detected. If light is not on and you have no fuel at schrader valve on rail- you can try inertia switch for fuel.
There is not an inertia switch on this car. The fuel system is computer controlled with relays. So you need to stat with checking for codes, check fuses, etc.
do you have to reset computer after changing battery in 2003 745li
You do not have to reset the computer.
There is nothing concerning the computer that needs to be reset.
No, you do not have to reset the computer. It will take care of itself.
no you dont have to reset the computer after changing the fuel pump
Not necessary. The computer will reset itself after a few driving cycles.
A Chrysler Sebring does not have a reset switch. The fuel system is computer controlled with relays.A Chrysler Sebring does not have a reset switch. The fuel system is computer controlled with relays.
You do not have to reset the computer any more than you reset your computer in your home after a power outage. It will take care of itself.
Yes, you do... But if you do within 1-2 minutes you might not reset the computer.
NO
AnswerA reset switch is to start something totally over. If a water heater stops heating, you can use the reset switch to start it working all over and see if there is a further problem.In computer hardware, which is the category you listed this question in, there is no reset switch on most modern computes. There is a power on/off switch, and you can restart the computer. On some older computers there is a reset button on the motherboard.
No, dodge doesn't use a reset switch Or inertia switch. The fuel pump is controlled by relays powered by the computer.