Remove the tire and wheel. Remove the brake assembly and rotor. Remove the axle end cap. The rear hub assembly will come off.
The best way to remove the rear axle on a Polaris Hawkeye is to spray it with PB blaster. After waiting several hours or a day, simply pull the axle outward.Ê
In CT USA, a garage would charge 1 hour labor to replace the rear brake pads on that Mountaineer.
Locate the starter at the rear of the engine on the passenger's side. Unplug the wiring. Remove the bolts that hold the starter. Remove the starter.
You will need a ratchet and a socket to remove it. You get under the rear of the truck and you will see the bolt and bracket holding the tire in place. Remove the bolt and the bracket hinges downward. You will need a ratchet and a socket to remove it. You get under the rear of the truck and you will see the bolt and bracket holding the tire in place. Remove the bolt and the bracket hinges downward.
How can remove the rear seat on a 1990 mercury sable
The rear seat is not designed to be removed. You can remove the center seat and slide the rear seat forward.
The rear seat is not intended to be removed. You can remove the center seat and slide the rear on forward into it's place.
You must remove the entire rear fender.
The rear seat isn't designed to be removed. If you have a center bench seat you can remove that by unclipping it, then slide the rear seat forward.
Remove the rear tire and wheel. Remove the axle end cap. Remove the rear wheel seal. Remove the rear wheel bearing. Reverse the process to install the new wheel bearing.
The rear seat does not come out. The middle seat is removable, after which you can slide the rear one up.
the rear speakers are located in the back doors. you have to remove the door panels to get at them.
With the correct sized socket, obviously.
See detailed instructions at the link below... http://www.autoclinix.com/Mercury/Rear%20Speakers.html
Support the transaxle and unbolt it. You may have to remove some things to get clear access to it.
14 mm.