Turn on that fast blinking signal light and check to see if the front and rear signal lights are both working, chances are you have a burned out bulb. If both front and rear bulbs are flashing fast, replace the flasher relay.
lift and support vehicle on stands, support engine with a jack with a 2x4, so you dont damage the oil pan. lift engine remove upper bolt for front motor mount then removed the three bottom bolts, remove and seperate the mounts. replace with new. replace all removed parts
Remove the light assy with the mounting screws.
You can find the alternator on the front, right hand side, of your engine. Remove the cables from the alternator. Remove the belt. Remove the retaining nuts. Reverse the process to install the new alternator.
Get your new sway bar and you will see what has to be taken loose to remove and reinstall it.
remove bumper, replace with new one.....easy huh ?
You need to remove the head lap it has some scews on the side and on front.
(1993 Pathfinder XE) First start by taking the front bumper ends off (3 nuts on each). Then remove the entire fog light assembly including the plastic trim surrounding it. Then there will be 4 nuts on each side (8 total) in a square pattern. Remove the bolts and pull.
look in your owner's manual
If its the front turn signal you open your hood and partly remove the black plastic cover on top of your headlights. Then you should see a screw on that screws on your signal light. Remove the screw and take off the the signal light and then remove the bulb.
trouble putting right front signal bulb in.
How do you replace a front turn signal bulb for a 2000 sts cadillac?"
Oh, dude, changing the front turn signal bulb on a 2006 Buick Lucerne is like a walk in the park... if that park was full of confusing car parts. You basically gotta access the back of the turn signal housing, twist out the old bulb, pop in the new one, and voila, you're signaling like a pro. Just make sure to not break anything or you'll be signaling with hand gestures for a while.
rear you use a torx driver to remove taillight assembly screws. them replace bulb.
I was quoted $900+ on the front struts for my '99 pathfinder. On ebay they said they found some for $200 less, but that's still $700+ just for front struts.
Open the hood. Near the front of the turn signal assembly there is a Phillips head screw. Loosen but do not remove the screw; it releases the front of the assembly. You then need to pull forward to release the pin holding the rear of the assembly. Reverse the above to replace the assembly.
To replace the turn signal switch of a 1996 Dodge Caravan, open the engine's hood to access the front turn signal bulbs. Then take the headlight assembly a little off the front to give room to get the bulbs. Remove the old turn signal switch and slip the new one in place.