0
Before taking the bike?æapart, check to be sure it has enough fluid and that the ohms and voltage are within normal range. If both of these check out, you can check either the plastic cage or the magnetic coil. You will have to take the bike apart to access these parts.
Add your answer:
Earn +20 pts
Is it safe to drive your car if the oil sending unit is out?
yes.if you know you really have oil pressure.
Basic unit of ecology?
Units1st unit: organism2nd unit: Population3rd unit: Community4th unit: Ecosystem5th unit: BiosphereWhat_is_the_basic_unit_of_ecology
Gmc jimmy - turn signals dont work - hazards work - replaced fuse and ts flasher - signals still dont work?
Well - it could be the turn signal unit in the steering column - if its a high mileage vehicle it may just be worn out. you have to remove the steering wheel and replace the unit - the part on a GMC is about $30 +/-. This may fix the problem.
The gram is the unit of?
the gram is a unit of mass.
Si unit for matter?
SI stands for Systems International. The unit for matter is kilograms. This unit can be used to describe the largest amount of matter to the smallest amount.
Can you use a 1999 two wheel drive dodge transmission in a 2000 dodge four wheel drive truck?
Only you swap the overdrive/tailshaft unit.
What fluid is located where the cv axles go into on a 2005 Chrysler pacifica?
Transmission fluid on a front wheel drive. All wheel drive unit fluid on a an all wheel drive.
Does a 4x4 1994 1500 Chevy silverado still lock in four wheel drive with out a fuse in the 4x4 slot of a fuse box?
If it has electric switch to shift into 4-wheel drive, your coil brake is stuck in the 4- wheel drive position. Take the shift unit off the transfer case and disassemble it. It is a small cylinder unit with gears and a servo in it. It should have 2 wires going to it. If you want to fix it, take it apart and check the coil brake located on at the end of the assembly. The two very small wires coming out of the coil may have corroded. This brake unit keeps the unit locked in position. If you do some very careful soldering and attach two small copper wires, same size as the old metal ones, to the small wires from the coil and use those to plug into the existing plug. Your Four wheel drive shifter should work again. I did this to my 2000 Sera instead of buying the $650 shift unit. Works great! If you can't fix it you must switch the unit to two wheel drive and put it back. You must also reach in the transfer case and switch it into four wheel drive.
Where is vacuum lines for 2000 Kia sportage four wheel drive?
vacume lines to 4weel drive unit are located on left sie fender under the hood right side if facing motor
How do you replace the front wheel bearings on a 95 Plymouth Voyager?
The front wheel bearing is a sealed unit with the wheel hub - replace the hub and wheel bearing unit. Remove the four bolts from the rear of the steering knuckle that connect to the hub bearing unit.
Can a 2001 town and country All wheel drive be converted to two wheel drive?
It would require removing the power transfer unit and replacing the transmission with the fwd only version.
What are the four 4 parts of all computers?
Motherboard, Power supply unit, Hard drive, Cd/drive.
In a 1999 Chevy Astro van what is the most common reason for the 'check 4 wheel drive system' light to come on?
Start by checking the "Motor encoder unit" on the all wheel drive system.
Is it possible to disconnect the front drive shaft on a 4 wheel drive unit and drive it without any problems?
On vehicles with a true 2wd position in the transfer case, yes.
Why do 1986 Toyota four wheel drive fuel injection turbo truck with 30000 miles start when you poor gas down the intake then die will not start unless you poor gas in the air filter intake?
why what is it a fuse a sending unit device what? why what is it a fuse a sending unit device what?
What is the location of oil sensor on 1999 Ford Expedition 5.4 Triton?
The oil pressure sending unit is threaded into the oil filter housing on a 2 wheel drive. A 4 wheel drive has the oil pressure sending unit located on the drivers side of the engine block just below the cylinder head.
Can you remove the driveshaft to your front axle for better mileage without harming anything?
I assume you are talking about a four wheel drive vehicle. If you have a transfer case that lets you select between 2 and 4 wheel drive you can remove the front shaft with no problem. Many later model vehicles do not let you chose 2 or 4 drive-- they have a limited slip unit in the transfer case. If you take out the front shaft in one of these, the rear shaft will not work.
