answersLogoWhite

0


Best Answer

The base or the solvent or the stain itself can be used to even out the color. Use a soft cloth and dampen it with the any of the three and rub it into the heavily stained area until you get the color even out.

User Avatar

Wiki User

18y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

13y ago

It's difficult to even out the color once you've already stained it. Too keep your stain color even, use a "sanding sealer" first to seal the wood surface and apply your stain over the sealer.

This answer is:
User Avatar

User Avatar

Wiki User

14y ago

Try to determine what the color is and get stain just slightly lighter. Newer wood is often softer than it used to be so it absorbs more color. Apply 1 coat and compare it to the old. You can put another coat on or let it sit longer to make it darker. The type of finish will affect it also. Depending on what you use, it will darken the finished board just a little bit.

This answer is:
User Avatar

User Avatar

Wiki User

12y ago

Sand the area when the overlap occurred. Then get a rag damp with the stain you are using. Make several passes over the area you just sanded, feathering in the stain as you get to the edges of where you sanded. You should avoid getting fresh stain on the surface that still has the dried stain on it.

This answer is:
User Avatar

User Avatar

Wiki User

12y ago

You get a can of the stain you want and experiment on a few pieces of the same wood till you get the colour you want. Don't put on too much at first, you can always darken it later.

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you correct overlapping of wood stain?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can you stain balua wood?

You can stain balsa wood.


What does a wood stain do to the wood underneath?

Wood stain is abosorbed into the wood, so the wood takes on the color of the stain. This is why the features of the wood are still visible, unlike with paint.


What is wood stain used for?

Wood stain is for sealing and emphasising the natural colour of wood


How to remove solid wood stain from pressure treated wood?

To remove solid wood stain from pressure-treated wood, you can sand the stained area with coarse sandpaper to strip off the stain. Alternatively, you can use a wood stain remover or stripper following the manufacturer's instructions. After removing the stain, clean the wood surface thoroughly and allow it to dry before refinishing.


What dinning room table wood is the most stain resistant?

Pine is the hardest wood to stain becuase it absorbs the stain to erratically. anonymous@oola.com


What is the effect if you apply wood stain without wood conditioner?

It could look blotchy depending on the type of wood and if it's a colored stain.


Can you use floor wood stain on rifle stocks?

Wood is wood.


Can you stain monkey pod wood?

what is best stain to use on monkeypod for clear look show the true wood


When doing wood finishing do you need to sand the old stain completely if the new stain is much darker?

I agree with Charles. I would also sand the piece of wood with the stain a bit then apply the darker stain.


What is the difference between a varnish and a stain?

A stain is used to color the wood while a varnish is a topcoat used to protect the wood.


Do you still make enterprise oil wood stain and if so where can I get it?

I am also looking for enterpris oil penitrating wood stain


Why does wood stain go on unevenly?

Wood varies in density.