0
Error 36 is a problem in Driver Side Airbag, Error 37 is passenger side.
We were getting the same symptom (error 36) on ours. After reading of more instances of the same I looked under the driver seat. There is a connector with two wires (white and brown) going into a yellow connector. This connector on mine apparently plugs into a resistor or some circuit element. I unplugged the connector by releasing the catch on the connector in the hole on the right side of the plug.
The two wires right at the connector looked like the wires had been pinched (the insulation was smaller there) This was actually because the copper wire inside the insulation was broken. Ford/Mazda used wire that is too stiff for a flex situation as this wire requires. I stripped the wires, soldered a short piece of more flexible stranded to allow the connector and wires to be connected together. ( taped and insulated with shrink tubing to be sure) No more Air bag light. - use or do at your own risk - good luck!
Add your answer:
Earn +20 pts
Why does the airbag light come on in your 2000 dodge neon?
The airbag light stays on when there is a malfunction in the system. The airbag computer will need scanned to know possible causes.
Airbag light reset 2000 Volvo s80?
In order to get your SRS Service Airbag light reset, You have to go to the Volvo dealership.
Where is the jimmy 2000 airbag light?
At the dash board manometer.
How do you reset airbag light on 2000 dodge neon?
The airbag light stays on when the computer has detected a malfunction and set a code. Clearing the code with out repairing the failure will not shut the light off.
Why is the seatbelt airbag light flashing in a 2000 Ford Explorer xls?
Warning lights are important to pay attention to and know warning lights. If seat belt lights flash, and an air bag light flash, it means there are problems with both parts.
Is there a separate fuse for the check engine light on a 2000 Ford Explorer?
According to the 2000 Ford Explorer Owner Guide : No , a separate fuse for the check engine light is not listed
How do you replace the Brake light on a 2000 ford explorer?
To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.
Would the airbag lite being on keep the heater blower from working in a 2000 ford explorer?
Yes , in the fuse box of your 2000 Explorer (located on the driver's end of the dash - the cover is visible with the driver's door open ) in location # 2 there is a brown colored 7.5 amp mini-fuse for the blower motor relay + airbag diagnostic monitor. Helpfull
Your check engine light blinks 3 times on your 2000 Yamaha roadstar what does that mean?
Something wrong with your throttle position sensor
Where is the fuse for the air bag light on a 2000 f 150?
The fuse for the airbag light on a 2000 F150 is under the dash. The fuse box is located under the driver's dash.
What would make the airbag light come on on a 2000 Chrysler 300?
The airbag computer has detected a malfunction. You need to have the system checked for codes to know possible causes.
Why 2000 vw beetle cold light stays on and sometimes blinks?
When the cold light comes on it is because the Coolant/Antifreeze is still cold, and that you should drive moderately until the engine reaches normal operating temperatures. When it blinks blue it usually means that there is an electrical malfunction with the cooling system somewhere. (usually the coolant sensor goes bad) If the light blinks red then the car is overheating.
