0
Add your answer:
Earn +20 pts
Where is the crank shaft position sensor on a 1999 Oldsmobile intrigue 3500 engine?
The crank shaft positioning sensor is behind the starter. A real bear to get to.
Where is the crank shaft positioning sensor located on a 94 ford probe?
2.0ltr its in distributer
Where is crankshaft positioning sensor located on 1986 ford van?
A 1986 ford van does not a crank shaft position sensor,, it uses the pickup in the distributer
Is it mandatory to take the vehicle to the dealer to reprogram crank shaft positioning sensor when replacing?
No. It's just plug in and go.
Replace crank position sensor 05 Nissan Altima?
Here is the link where you can see how to install Crank shaft positioning sensor with detail pictures. http://dentnshell.com/Projects/2005Altima/CamkPosition.html
Where is a crank shaft positioning sensor located in a 2003 altima?
It is in the oil pan. Nissan has had a recall to reprogram the sensor. They may have to replace the sensor for free. It cost about $600 for repair.
Where is the crank shaft positioning sensor on a 1998 Ford Mustang with 3.8 liter?
The crank sensor is located on the bottom of the timing cover under the right hand side of the water pump by the crankshaft pulley.
Where is the crankshaft sensor on a Chevy Blazer?
The crank shaft positioning sensor should be located at the front of the engine just below and to the left of the harmonic balancer. On the timing cover.
Would crankshaft positioning sensor cause no spark?
Yes. On some vehicles, the Crank Shaft Position sensor tells the computer that you are trying to start the vehicle. Without that signal, the ECM will not control the spark coil.
Where is the crank shaft sensor located in a Audi a4?
Where is the crank shaft sensor located in a Audi a6
You need to know how to remove the crank shaft positioning sensor for a 1989 2.8 lt. Chevy Celebrity with a V6 Thanks?
The answer depends on what engine you have.
Why would a ml 320 Mercedes Benz turn off in the middle of the freeway and not start?
When this happened on my 1999 ml 320, it was the crank shaft positioning sensor. After replacement-problem solved.
