yes
A 350 or 400 torque converter will not work on a Powerglide transmission due to differences in design. All are somewhat similar but come in different sizes and connections.
Sorry but it will not I have tried. The 400 is too wide and it won't bolt up correctly when the transmission is installed.
yes a 350 turbo converter will fit a 400 turbo and vice versa
Yes
No, that converter won't fit either tranny.
If you're talking about a TH400 transmission, yes... the TH350 torque converter is one inch smaller in diameter than the TH400 torque converter (12" vs 13"), and you'll have to make sure the holes on the flexplate line up (or drill them for both patterns). You'll get a bit more stall out of the 350 converter. If you're talking about the 700R4, the answer is going to be no.... that uses a lockup converter, which will not interchange with the TH converter.
Yes it will.. But You need to have a flywheel with two sets of bolt holes, 3 holes with a diameter 1 inch different pattern from the other 3. Atotal of 6 holes. The 350 converter has a higher stall than a 400, about 2/3 hundred. Because the 350 is smaller in diameter. It will work just fine.....!
not necessarily. depends on what it was made to do.
no
Aprox 12-13 qts.
A turbo 350 has only 3 gears. The 700R4 has 3 gears plus over drive and lock-up converter. And it is the same as a 400 turbo with overdrive.