0
Add your answer:
Earn +20 pts
Can a 1995 Jeep Wrangler hardtop fit onto a 1990 Jeep Sahara?
yes, any top for an 1987-1995 can be switched out
Will a 2001 Jeep Wrangler hard top fit onto a 2004 Jeep Wrangler?
Yes, that should be a good fit
How do you remove center console 99 wrangler?
Screws in the bottom hold it onto the floor.
Will a 91 Sahara hard top fit onto a 91 wrangler?
Yes, that should work just fine
How does a hard top attach 1993 jeep at windshield?
a '91 and it should be the same. If your top is a factory hardtop, then there are 7 screws across the top inside to fasten the top onto the windshield.
When did Beauty and the Beast first go onto the stage?
1994
WHen radiator changed in 1993 Jeep Wrangler windshield steam up?
The windshield streaming after a radiator change on a 1993 Jeep Wrangler is a result of a loose connection. Steam is caused when coolant leaks onto the engine and is heated rapidly.
Will vortec heads of a 350 fit onto a pre-1994 block?
== ==
How do you remove the shifter arm from the transmission on a 94 jeep wrangler?
remove access plate on floor around shifter, 4 bolts hold the shifter onto the trans.
What the year was gogle made?
In September of 1998, Google Inc. was put onto the web.
What is the serpentine belt routing for 1998 Jeep Wrangler 6-cyl with AC and power steering if the routing sticker under the hood is missing?
Pinch the belt into a loop, pass "the loop" down the right side of the fan & slip it onto the crank pulley,pass the "non-ribbed" side over the water pump, then left onto the alternator, then up onto the A/C, then down under the idler pully, & over to the power-steering pump and finally the "non-ribbed" side down to the adjustable idler pulley that sits below the Power steering pump.
How do you attach the hard top on a 500 SL?
Do you mean a 500 SL, or an SL 500? I have a '97 SL 500 (40th anniversary edition) and it's simple. 1) Lower windows. Park on flat surface. Put engine in "park" and turn engine off. 2) With a helper, gently set hardtop onto its position so straight brackets on rear are aligned with receiving pockets, and front of hardtop is squared over its receivers. 3) Turn key to AC position. 4) Push red tab button on center console (forward right button) forward until hardtop is fully pulled into receivers. Done.
