0
Sounds like a bad brake booster. If you are getting an extended braking distance, you may also want to check for a rear wheel cylinder leak.
AnswerYou also might want to check to see if the engine vacuum is low. If the vehicle is newer than '90 or so, it probably has a sensor that determines if the rear wheels are braking. If hydraulic pressure is uneven between front and rear you will usually see a brake indicator light come on. I agree that the vacuum assist may be the culprit, but also make certain that you are getting enough vacuum to the brakes. Low vacuum can be caused by a number of problems, so it may take a little checking. I would recommend a vacuum gauge. They are quite inexpensive and can be picked up at most auto parts stores.Also check to see if you have a vac. leak at the booster canister where the vac. line plugs into it, if the master cylinder is leaking brake fluid through the rear seal of the spool valve it can enter the power brake booster and destroy the diaphragm seal causing the power brake booster to fail....thus hard as heck brake pedal(meaning you have no vacuumn assist) it's easy to check for a brake fluid leak....just pull the master cylinder mounting bolts off the power brake booster(either 2 or 4 bolts or nuts) and look at the rear side of the master cylinder seal to see if brake fluid is prevalent, also with a light look inside the power brake booster for tell tale signs of brake fluid leakage.
Add your answer:
Earn +20 pts
Is the best way to utilize anti-lock brakes?
Press brakes with firm, hard pressure.
Which is the best way to utilize anti-lock brakes?
Press brakes with firm, hard pressure.
When hydroplaning begins do you press down on the accelerator and brake hard?
No, you just hit the brakes HARD.
Why do your brakes press down hard and do not stop?
They need to be loosend up a liddle bit.
What is the stopping distance of a car over 2200 kilos?
Depends on how hard you press the brakes
Ford F150 Brakes?
form_title= Ford F150 Brakes form_header= Drive safely with new brakes. When was the last time your brakes have been replaced?*= _ [50] Have you noticed any issues?*= () Yes () No Do you have to press hard on the brakes?*= () Yes () No
What does it mean when it's difficult to press on the brakes?
if it is hard to press on the brakes it usually indicates that you have a malfunctioning brake booster. Since brake boosters are vacuum assisted, it could also be that you have a disconnected vacuum hose or a leaking hose.
If your brakes go out and you slarm your foot on them does it make a noise?
yes it might if u press hard enough if they do go out u will no
What does it mean when you press on the brakes normally and the grab really hard?
You probably need new brake pads very soon.
Why is it hard to press down your brake pedal on a ford ranger?
more than likely you have air in brake line and need to bleed brakes
When braking a vehicle equipped with anti-lock brakes the driver needs to?
press down hard on the brake pedal, and continue to steer the vehicle.
Why does the oil pressure light blink when you press hard on the brakes?
Low oil level? Oil may "slosh" forward on hard stop causing a temporary drop in oil pressure
