answersLogoWhite

0


Best Answer

it could be your speed sensor gone on the gearbox, had the same trouble with my 1.4 zetec se. The other thing could be the tiny vacuum pipe under the inlet manifold, might have a tiny hole, and the pipe has sucked itself in until it has collapsed.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why won't rpm needle stabilize?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you stop a kawasaki vulcan from accelerating at startup?

You need to adjust the RPM in order to stabilize acceleration in your Vulcan.


Why is my Lincoln mark viii rpm needle stuck?

Probably hitting against the glass


Astra 1.7cdti wont rev past 3000rpm?

Astra 1.7 cdti wont rev past 300 rpm


Your car wont start past 1000 rpm?

This doesn't make since


Why does your RPM needle go up and down after you come to a complete stop with your 01 civic?

coul be the map sensor


Why would a 1998 Nissan Maxima's RPM needle go down to 3 or 1 and then turn off plus also shake when reaching speeds of 40 or higher?

Why would a 1996 Nissan maxima's RPM needle go from 2 to 6 and seven, back and fort like crazy.


Why wont your 94 dodge shadow rev past 4500 rpm?

Rev. limiter?


Where is RPM sensor on a 1997 Nissan Altima GXE located?

There is a grey 4 pin plug on top of the motor, close to the firewall, it controls the RPM, Speedometer, and Temperature gauges. Plug may become loose, causing no RPM needle movement.


Why won't a 1991 Eagle Talon TSI go passed 5000 RPM?

why wont a 1991 Eagle Talon TSI go passed 5000 RPM


Can heroin effect a mans performance in bed?

yes. you wont get to sleep with a girl cause you have needle marks in your arm. you will have a little needle 8-----) with no spem you homosexual


1988 mark vii gas needle bounces and rpm needle and temp needle Is the computer going out?

You have a bad ground. There is an easy repair Log onto Lincolnsonline.com and search for ground repair and it will give you step by step repair procedure. Good luck


What is the problem with your car Mazda premacy 1999 when it it is in idle the rpm goes below 1000rpm and the needle is irratic?

Could be a vacuum leak.